User manual TRICITY EBF4/4

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] This programme does not require the use of detergent. Cold prewash Main wash up to 65°C 2 cold rinses 1 hot rinse Drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 65°C 2 cold rinses 1 hot rinse Drying Main wash up to 65°C 1 hot rinse (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Rinse & Hold Any. Partial load (to be completed later in the day). Normal soil Crockery, cutlery, pots and pans 1 10 0, 1 12 Power wash 65°C 2 119 - 134 1, 3 - 1, 5 18 - 20 (1) BIO 50°C Normal soil Crockery and cutlery 2 50° BIO 115 - 125 0, 95 - 1, 05 15 - 17 Normal wash 65°C Normal soil Crockery and cutlery 3 101 - 114 1, 3 - 1, 4 14 - 16 (2) Quick wash Fresh soil Crockery and 65°C cutlery 4 30 - 40 1, 1 - 1, 2 12 - 13 (1) Testing programme for EN 50242 (see "Hints for Test Centres"). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of washing and drying have been extended. (2) Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil). This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. (3) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. 10 Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Set and start of the programme Turn the programme selector dial clockwise until the number of the programme you wish to select corresponds with the programme marker. Incorrect repositioning and fitting of the filters will produce poor washing results. NEVER try to remove the upper spray arm. If residues of soil have clogged the holes in the upper spray arm, remove them with a toothpick. Cleaning the filters The filters must be checked and cleaned from time to time. Dirty filters will degrade the washing result. The dishwasher filter system comprises a coarse/fine filter (A/B), a microfilter (C) and a flat filter (D). Some dishwasher will only have a coarse filter (A), a microfilter (C) and a flat filter (D). Unlock the filter system using the handle on the microfilter, and remove. MA40 Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water. Leave the door ajar to prevent the formation of any unpleasant smells. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. MA35 MA32 3. Turn the handle about 1/4 a turn anticlockwise and remove. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. [. . . ] This will prevent waste water from the sink running into the machine. Hooked over the edge of the sink using the special curved plastic guide (if provided with the machine). To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. [. . . ]