User manual TRICITY FD806W

[. . . ] INSTALLATION AND INSTRUCTION MANUAL REFRIGERATOR/FREEZER FD806W ECD806 Thank you for buying a TRICITY BENDIX DOMESTIC APPLIANCE To enable you to use your appliance effectively and safely, please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further information, please contact our Customer Care Department. TRICITY BENDIX CUSTOMER CARE DEPARTMENT P. O. BOX 47 NEWBURY BERKSHIRE RG14 5XL Tel: 01635 525542 Fax: 01635 42970 Guide to use the instruction book The following Symbols will be found in the text to guide you through the instructions Safety Instructions Hints and Tips Step by step instructions for an operation Environmental Information IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. [. . . ] Shellfish: Should be refrigerated and used up quickly. Pull the rear of the cover outwards towards the middle of the cabinet. Unscrew the bulb and replace it with a new 15 watt E14 SES bulb (available from your local Service Force Centre). Replace the cover by engaging its front edges in the recess of the light housing. Push in the rear towards the side of the cabinet and replace the screw. 5. 6. 10 Defrosting Your Appliance The fridge compartment is defrosted automatically. Defrost water from the cooling plate runs out of the drain and onto a tray on the motor compressor where it is evaporated. Droplets of water on the cooling plate during defrosting are quite normal and will freeze on the plate afterwards. In the freezer compartment, frost accumulates on the refrigerated shelves during normal operation. Defrosting should be carried out when the frost build up is approximately 6mm (¼") thick. To Defrost the Freezer 1. Wrap any food in layers of newspaper or blankets. Switch the appliance off at the wall socket and remove the plug. Remove the plug from the drain-hole (in the top of the refrigerator) by pulling downwards. After defrosting, clean and dry the interior, and replace the plastic plug. Switch the appliance on and replace any frozen food. 5. 7. Defrosting can be speeded up by putting bowls of hot (not boiling) water in the freezer and loosening the frost with a suitable plastic scraper. If the temperature of frozen food is allowed to rise during defrosting, its storage life may be shortened. When the Appliance is Not in Use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all of the food and clean the appliance, leaving the door ajar to prevent unpleasant smells. 11 WHAT HAPPENS IF SOMETHING GOES WRONG BEFORE contacting your local service force centre, check the following points: Symptom No power to the appliance Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. The light does not come on Ensure that the bulb is correctly fitted. Check the door light switch is not jammed. The temperature in the fridge or freezer section is too high Check the thermostat in the fridge is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliances operating limits of 10°C to 32°C. Relocate the appliance if necessary. The freezer door will not open Has door just been opened?If so leave for a few minutes to allow the air pressure to equalise. The compressor runs continuously Adjust the thermostat to give correct temperature control. [. . . ] Refit the bottom door by sliding it onto the centre hinge pin. Take the bottom hinge foot assembly (B) and transfer it over to the opposite side of the cabinet, being careful to retain any spacer washers fitted onto the bottom hinge pin. Push the hinge foot assembly (B) into the door bearing using the pin of the foot for location. Three holes will then line up with the hinge foot and screws (C) should be used to secure the hinge. [. . . ]