User manual TRICITY FD930W

[. . . ] The freezer compartment Freezing fresh food Thawing . Positioning the door shelves Maintenance and cleaning Internal cleaning External cleaning . When the appliance is not in use . Guarantee conditions . What happens if something goes wrong?Tricity Bendix Service Centres . TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY GROSS CAPACITY Fridge Freezer Fridge Freezer 150 60 cm cm 54. 5 cm 220-240 V / 50 Hz 130 W 1. 35 kWh 174 l 76 l 170 l 60 l NET CAPACITY STAR RATING 2 WARNINGS IT IS MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THE APPLIANCE FOR FUTURE REFERENCE. [. . . ] To carry out door reversal operate as follows: Remove the plastic cover (6) (which has a clip-in fitting) masking the bottom hinge; Remove bottom hinge (1); Slide out the lower door from middle hinge (2) and remove the latter; Slide out the upper door from pin (3), unscrew the latter and then screw it down into the hinge provided on the opposite side; Refit the upper door and the middle hinge on the opposite side; Refit the lower door and bottom hinge (1) on the opposite side, after having removed the plugs (7) and screws; these must then be refitted in the holes on the opposite side; Refit the plastic cover (6) on the bottom hinge. Remove handles (4-5) and refit them on the opposite side. The holes that are not used are to be masked with the plastic plugs removed. Warning: After having reversed the opening direction of the doors, check that all the screws are properly tightened. 5 3 2 5 4 1 6 7 YOUR APPLIANCE A B K J I 6 3 C D E 12 9 H G F A - Thermostat control for fridge and freezer compartments B - Dairy compartment C - Can storage shelfs with egg trays D - Movable shelf E - Bottle storage shelf F - Freezer calender (recommended storage times for frozen foods) and produce storage cards (write on / wipe off cards for recording what has been stored in the freezer and when) G - Freezing fresh foods H - Storing frozen food I - Salad drawer J - Glass shelf (for storing fresh meat) K - Storage shelves 8 OPERATION Setting the temperature The temperature inside the refrigerator and freezer is regulated by a single thermostat with 6 temperature positions and one «OFF» (O) position. Position 1 = minimum cold Position 6 = maximum cold Turn the thermostat dial to the required position; the intermediate position is usually the most suitable. The thermostat setting can vary as the temperature inside the refrigeration compartment depends on the following factors: ­ room temperature ­ how often the door is opened ­ how much food is stored ­ position of the appliance Important If the refrigerator is not defrosting correctly, it is possible that because a very low temperature has been selected and the motor is working continuously, which prevents the defrost cycle from operating. To ensure correct defrosting, a lower number should be selected on the thermostat and you should notice that the motor cuts out from time to time, which is correct. If you wish to return to a lower temperature, turn the thermostat to a higher number, however you should turn the setting lower occasionally to allow automatic defrosting. Freezing fresh food It is not necessary to adjust the thermostat setting when freezing fresh food. In any 24 hours you can freeze up to 3 kg. Place food to be frozen in the bottom drawer of the freezer as this is the coldest part. To help you use your refrigerator correctly, here are some more useful hints: Raw meat (beef, pork, lamb & wild fowl): wrap in polythene bags and place on top of the salad crisper. Meat can only be stored safely in this way for one or two days at the most. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom salad crisper. Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. The walls of the refrigerator are equipped with runners so that shelves can be positioned as desired. Fig. 6 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Fig. 7 D293 D040 11 Defrosting Refrigerator The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing into the fridge, periodically clean the water discharge hole in the centre of the V shaped drip collector at the back of the refrigerator compartment behind the fruit and vegetable drawer. [. . . ] Don't worry this is due to pressure difference which will quickly equalise and allow the door to open normally. If, after the above checks, there is still a fault, call your local Tricity Bendix Service Centre. Please make sure you give the model and serial number of the appliance. This information can be found on the rating plate inside the fridge compartment on the left side behind the vegetable drawer, or on the guarantee certificate. [. . . ]