User manual TRICITY HG242B

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. [. . . ] Water filling: 30¡-30¡-40¡ programmes: cold water filling 50¡-60¡ programmes: hot and cold filling 90¡ programmes: hot water filling The programme times are intended as a guide only. The actual time will vary depending on incoming water temperature and pressure. (**) If the rinse hold button has not been depressed. ¥Some programmes when selected may start with a short drain. This is quite normal and not a fault with the appliance. When a programme is selected, the selector dial will advance to the water filling position. Programme 2 is selected, there is a short drain. The appliance takes in water and the selector will appear to move to the 3 position. The appliance will have memorised the programme selected, in this case 2, and will run the correct programme even though the selector dial appears to be at position 3. ¥We recommend you not to switch the appliance off and on during its operation. This would modify the memorised programme in progress with unsatisfactory washing results. To aid cleaning, the top part of the additive compartment should be removed. P1114 ¥ Place a container close to the pump to collect any spillage. ¥ Pull out the emergency emptying hose, place it in the container and remove its cap. 15 ¥ When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. Clean the filters using a hard bristle brush. Tighten up the inlet hoses. P1115 P1090 · Remove any objects from the pump impeller by The dangers of freezing If the machine is exposed to temperatures below 0¡C, certain precautions should be taken. q Place the end of the emergency emptying hose and that of the inlet hoses in a bowl placed on the floor and let water drain out. q Screw the water inlet hoses back on and reposition the emergency emptying hose after having put the cap on again. q When you intend to start the machine up again, make sure that the room temperature is above 0¡C. Important! rotating it. ¥ Put the cap back on the emergency emptying hose and place the latter back in its seat. P1117 Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO valve avoiding that part of the detergent remains unused at next washing. ¥ Screw the pump cover fully in. ¥ Close the pump door. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: ¥ pull out the plug from the power socket; ¥ close the water tap; ¥ if necessary, wait until the water has cooled down; ¥ open the pump door; ¥ place a bowl on the floor and place the end of the emergency emptying hose into the bowl. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. [. . . ] Once in the right position fix the feet by pushing the nuts against the base of the case. Accurate levelling prevents vibration, noise and displacement of the machine during operation. After levelling the machine, secure the feet by tightening the ring nuts with the aid of a screwdriver. Some vibration is inevitable, especially if mounted on a wooden floor. [. . . ]