User manual TRICITY MW219TC

[. . . ] - - - - - - - - - - - - - - - - - - - - 25 Technical data- - - - - - - - - - - - - - - - - - - - - 29 Consumption values - - - - - - - - - - - - - - - - 30 Installation instructions - - - - - - - - - - - - - - 31 Environmental concerns - - - - - - - - - - - - - 35 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. Always unplug the appliance and turn off the water supply after use, cleaning and maintenance. Under no circumstances should you attempt to repair the machine yourself. [. . . ] The Delay Start cannot be selected with «Drain» programme. Start the programme by pressing button 8 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The appliance starts operating and the door is locked. To interrupt a programme which is running, press button 8 : the green pilot light starts to flash. To restart the programme from the point at which it was interrupted, press button 8 again. If you have chosen a delayed start, the machine will begin the countdown. If an option which is not compatible with the set wash programme is selected, the message Err is displayed for a few seconds and the red light of this button flashes 3 times. Altering an option or a running programme It is possible to change some options before the programme carries it out. Before you make any change, you must pause the machine by pressing button 8 . Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing button 8 again. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. Turn the selector dial to «Cottons» or «Synthetics» programme in the «Drying» section. If you wish to select the automatic drying (Cupboard dry or Iron dry), press button 3 until the light corresponding to the desired dryness degree for synthetics or cotton illuminates. If you wish to select a timed drying, press button 4 until the time you want appears on the display (see the drying programmes). The drying time will automatically increase by up to 2 minutes. After the programme has started, the time remaining is updated every minute. At the end of the programme, the buzzer sounds. A flashing zero «0» appears on the display. The last 10 minutes of the drying cycle correspond to an anti-crease phase. During this time the door is locked and the display keeps showing the flashing zero «0». If you wish to open the door before or during the anti-crease phase or to interrupt it, press any button or turn the programme selector dial to any programme position (except «O»), the door can be immediately opened. [. . . ] 90 cm (35. 4) contact your local water authority. SHOWER SINK BATH TOILET BIDET Blue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . - Neutral Brown. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . - Live The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal marked «N» or coloured black. GREEN & YELLOW E 13 A WASHING MACHINE RAINWATER 'RUN-OFF' DISHWASHER FOUL DRAIN SURFACE WATER DRAINS & SEWERS FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHARGE RIVER RIVER N L UNTREATED DISCHARGE BROWN BLUE CORD CLAMP Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door and in the chapter «Technical Data». Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. [. . . ]