User manual TRICITY RF400W

[. . . ] Knives and other items with sharp points must be loaded in the cutlery basket with their points down or placed in a horizontal position in the upper basket. Only use products (detergent, salt and rinse aid) suitable for dishwashers. Avoid opening the door whilst the appliance is in operation, hot steam may escape. Do not take any dishes out of the dishwasher before the end of the dishwashing cycle. [. . . ] - continuous flashing of the indicator light of the running programme - 1 intermittent audible signal q q Possible cause and solution The water tap is blocked or furred with limescale. The filter (where present) in the threaded hose fitting at the water inlet valve is blocked. Clean the filter in the threaded hose fitting. The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Check the water drain hose connection. q - 1 flash of the "End" indicator light q The dishwasher will not drain. - continuous flashing of the indicator light of the running programme - 2 intermittent audible signals - 2 flashes of the "End" indicator light q q q The programme does not start. q The dishwasher door has not been properly closed. Close the door The main plug is not plugged in . Insert the mains plug The fuse has blown in the household fuse box. Replace the fuse. q Once these checks have been carried out; switch on the dishwasher, press the Programme/Cancel button and close the door. The programme will continue from the point at which it was interrupted. Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. CAUTION!If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. Inlet hose Connect the inlet hose to a water tap with an external thread of 3/4". The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. Drain hose - Connect drain hose to the sink. - Required height: 30 to 100 cm above bottom of the dishwasher. - If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. 22 CAUTION!Always be sure, that there is no water leakage from hoses and their connections after the installation. Ensure that the hoses are not kinked, crushed or entangled. Electrical connection WARNING!Safety standards require the appliance to be earthed. The manufacturer accepts no liability for failure to observe the above safety precautions. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. [. . . ] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]