User manual TRICITY RF506GR

[. . . ] Partial load (to be completed later in the day). 2 On/Off 25 g / ** QUICK WASH RINSE AND HOLD 3 On/Off 25 g / 4 On/Off / / * Testing programme for EN 50242 (see "Hints for Test Centres"). ** This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Hints for test centres Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser Test standard: Reference programme: Load: Rinse aid selector: Detergent dosage: EN 50242 NORMAL 65°WITH PREWASH 8 standard place settings position 4 20 g in the dispenser 5 g on the dispenser lid Arrangement upper basket Arrangement lower basket Arrangement cutlery basket 3 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning" Instruction book part 1). 8. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. 2. Check that there is rinse aid and salt (See Instruction book -part 1). 9. Switch off the dishwasher Wait 15/20 minutes before opening the dishwasher's door; in this way you will avoid burning yourself when removing the dishes and avoid also the damage of the nearby furniture caused by the escape of steam. Switch off the dishwasher by pressing the On/Off push button. [. . . ] Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. 5. Important!To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the cup rack. RC01 After loading your machine always close the door, as an open door can be a hazard. 6 Technical specifications Dimensions Width Height Max depth Max depth with open door Voltage 44. 6 cm 81. 8 - 87. 8 cm 55. 5 cm 111. 4 cm 220/240 V - 50 Hz 200 W 2800 W 3000 W 50 kPa (0. 5 bar) 800 kPa (8 bar) 8 place settings Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Minimum Maximum Capacity Fitting under a counter (kitchen worktop or sink) By removing the machine's worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. Proceed as follows: - Remove the machine's worktop by unscrewing the two front retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. 570- 600 450 IN04 Levelling Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. [. . . ] When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. IN11 820 IN12 7 Tricity Bendix, 55-77 High Street, Slough, Berkshire, SL1 1DZ Customer care telephone number. . . 08705 950 950 From the Electrolux Group. [. . . ]