User manual TRICITY SN55GLMWL

[. . . ] Whenever possible, the back of the appliance should be close to a wall, but leaving the required distance for ventilation, as stated in the installation instructions. The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle. Child Safety Do not allow children to tamper with the controls or play with the product. Keep packaging material away from children! [. . . ] Do not use soap or detergent as the smell may linger. Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or products containing alcohol. 1. Allow the appliance to stand for 2 hrs after installation. Plug in the appliance and switch on at the mains supply. Turn the thermostat control to the required setting. A setting of 3 is usually suitable for normal operation (see thermostat control). Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside. F To Start the Appliance Thermostat Control The thermostat control situated inside the refrigerator regulates the temperature of the larder compartment. Thermostat control is marked from 1-5 the higher the number, the colder the setting. Position 0 Position 1 Position 5 - Off - minimum coldness - maximum coldness Hints for storage Below is the recommended storage positions for various food types: 1. Ready-cooked foods, convenience foods, fresh meat, cold cuts 2. Milk, dairy products, foods in dishes 3. The temperature in the appliance is too low Excessive frost and ice has built up The appliance is noisy. Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the ambient temperature is within the appliances operating limits of 16 °C to 32 °C. Check that the thermostat control knob is turned to the correct setting relative to ambient conditions. Set the thermostat control knob to a warmer position. Check nothing is preventing the door from closing. Check the door gasket is intact and clean. Check if the appliance stands stable (all four feet should be on the floor). Check the drain hole is not blocked (see 'Maintenance and Cleaning'). The temperature in the appliance is too high If after the above checks your appliance still does not operate correctly, contact your local Tricity Bendix Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made, as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. 9 War r ant y and ser vice Guarantee conditions Service and spare parts If calling the service is unavoidable, announce the trouble at a brand-mark service nearest to your place. [. . . ] Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol. 11 Ventilation Requirements The appliance must have adequate ventilation to ensure correct operation. Diagram shows the ventilation requirements when installed: A* Under a worktop, or cupboard. * The clearance space of 10 cm above the appliance may be reduced to 5 cm providing a clearance space 2. 5 cm is left on either side of the appliance. B When freestanding Levelling The appliance must be level. [. . . ]