User manual TRICITY TB25TR

[. . . ] OPERATING & INSTALLATION INSTRUCTIONS REFRIGERATOR TB 25 TR 1312533 A/T/5-3. (01. ) This instruction book contains safety precautions, hints, information on use and helpful hints and tips. To ensure you use this appliance effective and safely, please read this instruction book carefully before installing or using this appliance and retain for future reference. The symbols below help you to find things more easily: Safety precautions Warnings and Safety information Hints, useful information Environmental information 2 IMPOR TANT S AFET Y INS TR UCTIONS These warnings are provided in the interests of your safety. [. . . ] Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner. Frozen food storage Storing ready-frozen foods is quite straightforward. The packs can be placed beside each other or on top of each other. You are strongly advised to place ready-frozen food in the compartment as quickly as possible after purchase and we therefore recommend that you buy them last. Also ensure that the external packaging is intact. Maint enance & Cleaning Before any maintenance of cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY SUPPLY. Internal Cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0. 5 litre of water). Rinse and dry thoroughly. 7 NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. This frost, acts as an insulator and prevents the cold from reaching the insulator food. The frost should be removed whenever the thickness of the frost exceeds 1/4. To carry out complete defrosting proceed as follows. Pull out the plug from the wall socket or turn the thermostat control knob to the '0' position. Leave the fridge and ice-making compartment doors open, when defrosting is completed, dry the appliance thoroughly. Remove any defrost water collected in the tray. Replace the plug in the socket or return the thermostat to the initial position and, after letting the appliance run for at least an hour, place the food in the evaporator compartment. External Cleaning Wash the outer cabinet with warm soapy water. When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door open to prevent unpleasant smells. Defrosting While the appliance is in operation the ice-making compartment becomes progressively covered with frost. Some thing N o t Wor king If the appliance is not working correctly, please carry out the following checks before contacting your local Tricity Bendix Service Force Centre. Problem No power to the appliance Possible Cause No power at the socket. The appliance is located in an unsuitable position. The temperature in the appliance is too low Excessive frost and ice has built up The appliance is noisy. Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the ambient temperature is within the appliances operating limits of 16 °C to 32 °C. Check that the thermostat is turned to the correct setting relative to ambient conditions. Check nothing is preventing the door from closing. Check the door gasket is intact and clean. Check if the appliance stands stable (all four feet should be on the floor). The temperature in the appliance is too high If after the above checks your appliance still does not operate correctly, contact your local Tricity Bendix Service Force Centre. [. . . ] In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow: Blue: Brown: Earth Neutral Live The wire coloured green and yellow must be connected to the terminal marked with the letter E or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal N or coloured black. [. . . ]