User manual TRICITY WDR1242W

[. . . ] User manual Washerdryer WDR 1242 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Contents Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel - - - - - - - - - - - - - - - - - - - - - -6 Functions - - - - - - - - - - - - - - - - - - - - - - - - -9 Programme table - - - - - - - - - - - - - - - - - -10 Programme information - - - - - - - - - - - - - -12 Washing and drying hints - - - - - - - - - - - - -13 Before the first use - - - - - - - - - - - - - - - - -16 Operating Sequence - - - - - - - - - - - - - - - -16 Washing - - - - - - - - - - - - - - - - - - - - - - - - -16 Drying only - - - - - - - - - - - - - - - - - - - - - - -19 Autodrying - - - - - - - - - - - - - - - - - - - - - - -20 Drying programmes - - - - - - - - - - - - - - - - -21 Care and cleaning - - - - - - - - - - - - - - - - - -22 What to do if. . . [. . . ] Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing button 8 again. The washing water in the tub will not empty out. Interrupting a programme Press button 8 to interrupt a programme which is running, the corresponding light starts to flash. Press this button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing button 8 . If the light 9 goes off, the door can be opened. If this light doesn't go off and the door remains locked, this means that the machine is already heating, that the water level is above the bottom edge of the door. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O». After a few minutes it will be possible to open the door (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to press button 8 . At the end of the programme The washer-dryer stops automatically. Some acoustic signals sound and on the display will appear a flashing «0». The button 8 light and the light 9 go off. The door can be opened. 18 If, at the end of a programme, there is water in the tub, (the light 9 still on) to empty out the water follow the following instructions: To empty out the water proceed as follows: 1. turn the programme selector dial to «O» 2. select the Drain» or «Spin» programme 3. reduce the spin speed, if needed, by pressing button 2 4. at the end of the programme, the display shows «0», the light 9 goes off. It will be possible now to open the door. Turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. [. . . ] The manufacturer declines any responsibility for damage or injury through failure to comply with the above safety precaution. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. [. . . ]