User manual TRIMBLE SNM910 CELLULAR MODEM QUICK REFERENCE CARD

[. . . ] Remove the rubber end caps on the host device. Use the four screws included in the kit to attach the bracket to the host device. Replace the rubber end caps. IBSS Field Base setup using the SCS900 system Use a tripod or T-bar to set up the base station and then use the tripod clip or holes in the mounting bracket to mount the system. Note: You must use a radio antenna cable and external antenna for the internal radio. [. . . ] You have entered an incorrect CPIN 3 times; enter the 8-digit PUK supplied by the Service Provider. Internet connection is in progress The SNM910 could not connect to the ISP. Unknown TCC Device ID, incorrect user name or password. No response or No GNSS Data from IBSS or NTRIP source. IBS Base sending correction data to IBSS. Using the front panel to control an IBSS field base panel Once the IBSS Field Base has been configured, it can been turned on and turned off from the front panel: 1. From the home screen, press L J L in turn, and then press J or K to select either: ­ Connect ­ Disconnect ­ Reset Note: To view the GPRS Signal strength (RSSI) on the SNM910 status you need to use the Disconnect command. When you are in a location with good signal then use the Connect command to start the connection. Press L to activate the command. 4 IBSS 900 MHz Rebroadcaster setup Trimble recommends that you configure the SNB900 radio as a Rebroadcaster in the office before mobilisation. Insert the SIM card and attach the bracket (as described earlier). Insert the SNM910 modem into the bracket and tighten the thumbscrews. Connect adapter P/N 57158 to the 26-pin connector on the modem and then connect the power cable to the adapter. Use an Ethernet cable to connect a laptop running the Windows® operating system to the adapter and then turn on both the SNM910 modem and the SNB900 radio. Note: The laptop must not have any existing wireless or wired ethernet connections. Press n to navigate to the Protocol screen and then press K to select Easy IP. After the modem has saved and rebooted, press n to navigate to the Mode screen and then press K to select Rebroadcaster. Press J to navigate to the Ethernet Addr screen and make a note of the IP address (normally 169. 254. 2. 1). Open a browser application (for example, Mozilla Firefox or the Internet Explorer® internet browser) and then enter the IP address into the address field. Open the SNM910 Modem page and then click Configure to set the APN, CID, user name, and password provided by your Internet Service Provider. Click apply Settings and then click reboot to reboot the radio. Open the IBSS/NTRIP Client page, set the Mode to IBSS, enter the TCC Org, TCC Password, and Base Name and then click Save Changes. Note: Base Org is required only if the Base belongs to a different TCC Organisation. Open the Configure wireless page, set the Network number and Easy IP name for the 900 MHz radio and then click apply Settings. [. . . ] No response or no GNSS data from IBSS or NTRIP source. Lost ISP connection, will re-establish NTRIP/IBSS when reconnected to ISP. The SNM910 modem is connected to IBSS/NTRIP. "Data" may be replaced by the correction type, for example, CMR. © 2010. [. . . ]