User manual TRONIC KH 378 PORTABLE TOP-LOADING CD-PLAYER WITH RADIO

[. . . ] If the pole clamps touch each other there is risk of short-circuit. We wish to point out that even standard vehicle models are equipped with numerous electronic devices (ABS, ASR, on-board computer, etc. The high starting voltage and voltage peaks may cause damage to these electronic components. We cannot assume any liability for consequential damage caused by the jump starts function. [. . . ] Connect the red cable (+) of the power station with the POSITIVE pole (+) of the vehicle battery. Connect the black cable (-) of the power station with the body of the vehicle, for example to the grounding strip or any other bare point on the engine block. Clamp this cable as far as possible from the battery in order to prevent ignition of any explosive gas that may develop. The switch (Figure 1 / Item 1) must be in the "ON" position when performing a jump start. Turn the ignition key over to start position and wait approx. After two minutes you may attempt to start the engine with the power station connected. Be sure not to attempt to start the vehicle for longer than 5 seconds due to the very high current involved. After the successful start, first disconnect the pole clamp on the grounding strip (negative pole). Then disconnect the jumper cable from the POSITIVE pole (+) of the car battery. The power station will need to be recharged after this giving this jump start. The power station is equipped with a maintenance-free storage battery, which is only partially charged when delivered. This condition can occur after giving a jump start, for example. Continuing to operate the unit in this condition may damage the battery. The storage battery discharges automatically when the power station is not used for a long time. It should be recharged every 3-5 months, regardless of the amount usage, in order to preserve the operating life of the battery. Important Information for your Safety" prior to working with the compressor. Allow the compressor to cool for at least 10 minutes after it has run for 10 minutes. â· Check the pressure gauge before switching on the compressor (Fig. 1 / Item 6) can be turned on and off by using the switch (Fig. Replacing the Bulb The lamp must be turned off to replace the bulb. 1 / Item 6) together slightly from the sides, then pull the cover off. Screw the bulb into the socket in a clockwise direction. [. . . ] Secure the connector piece by flipping back the locking lever (Fig 2 / Item 2). Be sure to switch off the power station and to disconnect all devices before performing cleaning or maintenance work. â· Usually, a soft, dry towel is sufficient to clean the surface. If necessary, dirt can be removed with a slightly dampened rag. [. . . ]