User manual TRONIC KH 3900 POWER INVERTER

[. . . ] When connecting the power inverter via the 12 V vehicle plug make sure that the polarity of the vehicle plug matches the polarity of the in vehicle receptacle. The vehicle socket must have an internal positive pole, that is to say that the positive pole of a vehicle battery cannot be connected to the chassis of the vehicle. Check before connecting the power inverter that the vehicle receptacle is sufficiently secured. This safeguard may not in any way be circumvented or changed. [. . . ] For this, install cables so that they do not come into contact with moveable parts in the vehicles interior and they do not obstruct the view. Loosen the red screw on the power inverter as much as is needed for you to be able to place the red cable shoe of the 12 V vehicle cable with the opening under the screw and washer. (See diagram: Cable shoe connection) · Turn the red screw so tight that the cable shoe can no longer become unattached. Loosen the black screw on the power inverter as much as is needed for you to be able to place the black cable shoe of the 12 V vehicle cable with the opening under the screw and washer. Turn the black screw so tight that the cable shoe can no longer become unattached. The power inverter can also be operated when the engine is switched off. However be aware that the power inverter possibly may not function during an engine startup. Before connecting a load/device to the power inverter make sure that the on/off switch on the device is in the position 0. Make sure that the power of the load/device does not exceed the maximum continuous load of the power inverter. Insert the plug of the connecting load/the device to be operated into the 220 - 240 V socket of the power inverter. Due to high crossover resistances heating of the plug in connector can result when using the cables with a 12 V vehicle plug. Therefore when operating with high loads use the connection cable with the connection terminals. Loosen the red screw on the power inverter as much as is needed for you to be able to place the red cable shoe of the red cable with the connection terminal with the opening under the screw and washer. Turn the red screw so tight that the cable shoe can no longer become unattached. Loosen the black screw on the power inverter as much as is needed for you to be able to place the black cable shoe of the black cable with the connection terminal with the opening under the screw and washer. Turn the black screw so tight that the cable shoe can no longer become unattached. First connect the red terminal clamp to the plus pole of the automobile battery and then the black terminal clamp to the minus pole of the battery. Switch the power inverter on by moving the on/ off switch to the position I. If the power inverter is functioning properly the operation LED/Overload indicator will light up green. When switched on a short signal tone can be heard. If a signal tone can be heard and the operation LED/ Overload indicator lights up red the input voltage is too low or the power of the load/device connected to the power inverter is too high. Do not use the power inverter in vehicles whose plus pole is connected to the vehicle body and/or the chassis. [. . . ] The warranty covers only claims for material and maufacturing defects, not for wearing parts or for damage to fragile components, e. If this product has been subjected to improper or inappropriate handling, abuse, or modifications not carried out by one of our authorised sales and service outlets, the warranty will be considered void. Your statutory rights are not restricted in any way by this warranty. Den här apparaten ska anslutas till ett 12 V uttag i ett internt elnät eller till ett bilbatteri och användas för att avge 220 - 240 V växelspänning för anslutning av elektriska apparater med en effektförbrukning på upp till 300 W. [. . . ]