User manual TRUST PW-4130M 1300VA MNGT UPS

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ] Press the FUNC key, and while is displayed on the LCD, press the beep sounds, then " " flashes on the display. A 4 NOTE: When " " is flashing in step 3 (when the memory contents are displayed as is on the display), it is still possible to cancel the operation by pressing the FUNC key, and while is displayed on the LCD, press the key. After changing channels or modes, this is no longer possible. 4. 5. 4 Programming a Repeater-Access Function Setting The "Repeater-Access" function is to set the desired shift and tone parameters to the current operating frequency by just 2 key-touches. Please set the parameters to be applied to the Repeater-Access function here. Enter the Memory mode (by pressing the key if necessary). Set the most commonly used Repeater-Access parameters by referring to "RepeaterAccess" (page 43). The parameters can be programmed in this memory are marked * in the chart on the next page. By activating the Repeater-Access function these settings are applied to the operating frequency regardless of the VFO/Memory/CALL modes, by temporary replacing the current parameters. After programming is completed, press the FUNC key then press the while MrpALL is displayed to store the edited parameters. Rotate the dial to operate in the Memory mode by selecting channels or press the key for VFO mode operation. 27 4. Basic Operation 4. 5. 5 Programmable Parameters in Memory Channels The following parameters can be stored in each of the memory channels. · Frequency · Offset frequency * · Shift direction (+/-) * · Tone encoder frequency * · Tone decoder frequency * · Tone encoder/decoder setting (TSQ) * · DCS code * · DCS setting * · Skip channel setting · Busy channel lockout (BCLO) · Transmission power (H/L) · Battery save setting · Clock Shift setting · Alphanumeric channel tag · Attenata Level 4 NOTE: Only parameters marked "*" are programmable in Repeater-Access function memory. 4. 6 Call-Channel Mode This mode is used to recall a most frequently used memory channel (stored in MC channel) with a single key-touch. IMPORTANT NOTE: The output level can't be altered while transmitting. 30 5. Useful Functions 5. Useful Functions 5. 1 Scan Modes The scan function automatically searches the receiving signals. There are 2 modes for scan-resume condition. · Busy Scan: The scan stops when a signal is detected, stays until the signal is gone then resumes scanning. · Timer Scan: The scan stops when a signal is detected, and resumes scanning after 5 seconds regardless of receiving status. During scanning, the 1MHz decimal point ( ) on the frequency display flashes. Press any key other than the MONI key to stop scanning. Scanning starts in the direction of the last dial operation (up or down). NOTE: Please refer to the Set mode to switch the setting between Timer and Busy scan modes (page 45). 5 5. 1. 1 VFO-Scan 1. The unit scans in accordance with the order 3. Rotate the dial clockwise/counter-clockwise to change the scan direction. VFO-scan scans the entire frequency range. [. . . ] Connect the AC adapter plug to the DC-IN jack on the back of the basket. *The design of the AC adapter may vary depending on the models. Connect the adapter to an outlet. AC adapter* AC adapter plug Basket 3. Press the sides of the adjustment plate, and attach it to the proper grooves of the basket according to the size of the battery pack. [. . . ]