User manual TYAN S8005-S8005WAGM2NR

[. . . ] Windows is a trademark of Microsoft Corporation. IBM, PC, AT, PS/2 are trademarks of IBM Corporation. INTEL, Pentium II, Pentium III, Celeron are trademarks of Intel Corporation. S1846 Tsunami and Tsunami-ATX are trademarks of TYAN Computer Corporation. [. . . ] The settings are Disabled, 16, 32, 48, 64, 80, 96, 112, 128, 144, 176, 192, 208, 224, or 240. AGP SERR Set this option to Enabled to enable the AGP SERR signal. AGP Parity Error Response Set this option to Enabled to enable AGP parity error response. 8bit I/O Recovery Time This option specifies the length of a delay inserted between consecutive 8-bit I/O operations. The settings are Disabled and from 1 to 8 Sysclk (system clocks) in increments of one. S1846 Tsunami ATX 51 Chapter 3 BIOS Configuration 16bit I/O Recovery Time This option specifies the length of a delay inserted between consecutive 16-bit I/O operations. The settings are Disabled and from 1 to 4 Sysclk (system clocks) in increments of one. PIIX4 SERR# Set this option to Enabled to enable the SERR# signal for the Intel PIIX4 chip. USB Passive Release Set this option to Enabled to enable passive release for USB. PIIX4 Passive Release Set this option to Enabled to enable passive release for the Intel PIIX4e chip. This option must be Enabled to provide PCI 2. 1 compliance. PIIX4 DELAYED TRANSACTION Set this option to Enabled to enable delayed transactions for the Intel PIIX4 chip. The settings are Disabled, and from 1 to 15 minutes, in one minute intervals. Power Saving Type There are several types of sleeping states within the general sleep state. This option allows you to choose how asleep you want your system to be. In deeper sleep modes, more energy is saved. However, upon waking up, the system must reorient itself, and reestablish control over the systems sleeping components. The settings are POS, Sleep, Stop Clock, and Deep Sleep. POS is the lightest sleep mode; Deep Sleep is the heaviest. Standby/Suspend Timer Unit This option specifies the unit of time used for the Standby and Suspend time out periods. The settings are 4 msec, 4 sec, 32 sec, or 4 min. Standby Time Out This option defines the length of time that the system, while in Full On state, must be inactive before it enters Standby mode. The settings are Disabled and from 4 minutes to 508 minutes, in increments of 4 minutes. [. . . ] Devices and operating systems that are not Plug and Play require you to reconfigure your system each time you add or change any part of your hardware. The term RAM (Random Access Memory), while technically referring to a type of memory where any byte can be accessed without touching the adjacent data, is often used to refer to the systems main memory. This memory is available to any program running on the computer. GLOSSARY ROM (Read-Only Memory) is a storage chip which contains the BIOS (Basic Input/Output System), the basic instructions required to boot the computer and start up the operating system. SDRAM (Synchronous Dynamic RAM) is so-called because it can keep two sets of memory addresses open simultaneously. By transferring data alternately from one set of addresses, and then the other, SDRAM cuts down on the delays associated with non-synchronous RAM, which must close one address bank before opening the next. S1846 Tsunami ATX 87 Glossary Appendix 2 The serial port is so called because it transmits the eight bits of a byte of data along one wire, and receives data on another single wire (that is, the data is transmitted in serial form, one bit after another). SIMM Single In-line Memory Modules are the most common form of RAM. [. . . ]