User manual TYAN THUNDER K7X PRO

[. . . ] Thunder K7X Pro /// Revision 1. 50 S2469 Copyright © TYAN Computer Corporation, 2001-2002. No part of this manual may be reproduced or translated without prior written consent from TYAN Computer Corp. All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. TYAN, Thunder K7X Pro S2469 are trademarks of TYAN Computer Corporation. [. . . ] 32MB 64MB 128MB 256MB None None Single bit Multiple bits Both Disabled EC (Single bit) ECC (multiple bits) ECC Scrub Defines the size of system memory reserved for AGP graphics data such as textures. Usually, the higher the setting, the better AGP performance, regardless of how much actual RAM you have installed on your motherboard. Toggles the ERR signal in the listed conditions. EC ­ Error checking and status reporting enabled. ECC Scrub ­ ECC with memory contents corrected after all reads with errors. Graphics Aperture SERR Signal Condition ECC Config 3. 3 ­ Keyboard Configuration Screen Options related to keyboard setup can be altered in this section. Boot up Num-Lock Auto Toggles the Num-lock keyboard function to be On turned on at startup or be disabled at startup. Off 30/sec Defines the rate at which characters are 26. 7/sec repeated on screen when holding down keys on 21. 8/sec the keyboard. 18. 5/sec 13. 3/sec 10/sec 6/sec 2/sec 1/4 sec Defines the delay when holding down a key 1/2 sec before characters begin to repeat. 3/4 sec 1 sec This option toggles whether the system will pause if a keyboard error is detected or continue to boot. Keyboard auto-repeat rate Keyboard auto-repeat delay KB error 26 http://www. TYAN. com 3. 4 ­ I/O Configuration Options related to I/O setup can be altered in this section. PS/2 Mouse Floppy disk controller Serial Port A (. . B) Toggles the PS/2 mouse port. Toggles the onboard floppy disk controller. Leave as Enabled or set to Auto if you plan to use a floppy disk drive. Enabled Toggles the use of the onboard Serial Ports. Disabled Enabling the ports will require system resources Auto such as IRQs. 3F8, 2F8 These options are dependent on the IRQ 3E8, 2E8 settings below and vice versa. They set the I/O address for the serial ports. IRQ3 These options are dependent on the Base I/O IRQ4 settings and vice versa. Use this port for Disabled devices such as printers or Zip drives. Auto Defines the mode that the Parallel port will operate in. Leave on default setting for most compatibility. These options appear when the Parallel Port is enabled and allows you to set the Base I/O address. IRQ5 These options appear when the Parallel Port is IRQ7 enabled. [. . . ] PCI card that allows a RAID card to use the onboard SCSI chip, thus lowering cost of RAID solution. ZIF Socket (Zero Insertion Force socket): these sockets make it possible to insert CPUs without damaging the sensitive CPU pins. The CPU is lightly placed in an open ZIF socket, and a lever is pulled down. This shifts the processor over and down, guiding into the board and locking it into place. 35 http://www. TYAN. com Technical Support If a problem arises with your system, you should turn to your dealer for help first. [. . . ]