User manual TYAN TIGER 230T

[. . . ] TM Tiger 230T S2507T User's Manual Revision 1. 00 Copyright © Tyan Computer Corporation, 2001. No part of this manual may be reproduced or translated without prior written consent from Tyan Computer Corp. All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. Tiger 230T S2507T is a trademark of Tyan Computer Corporation. Intel, Pentium III DP, Celeron are registered trademarks of Intel Corporation. [. . . ] [Default setting is Enabled] Sets whether the Num Lock key should be enabled during bootup. [Default is Enabled] Refers to the method that the system addresses memory above 1MB. [Default is Normal] Sets whether the keyboard input speed should be altered. [Default is Disabled] If above setting is Enabled, this sets the characters per second of keyboard input. [Default is 6] If above setting is Enabled, this sets the delay on character input from keyboard. [Default is 250] Sets whether the password should be enabled. [Default is Enabled] Boot Up Floppy Seek Boot Up Numlock Status Gate A20 Option Typematic Rate Setting Typematic Rate Typematic Delay Security Option PS/2 Mouse Function Control MPS Version Control for OS Reserved. [Default is 1. 1] OS Select for DRAM > 64MB If your OS requires this setting, it can be altered from here. [Default is Non-OS2] Allows the S. M. A. R. T. protocol to report server system information over a network. [Default is Auto] Allows the BIOS to report to Win95 that no FDD exists (if this is the case). Mode Report no FDD Video BIOS Shadow C800-CBFFF Shadow to DC000-DFFFF Shadow Reserved. [Default is Enabled] EPA Logo Select Provides the options for the EPA logo. [Default is LOGO-0] Report no FDD Provides the option to show the smaller EPA logo. [Default is Off] 34 http://www. tyan. com 3. 4 Advanced Chipset Features This section describes the settings for the chipset installed on this motherboard. Please note that the parameters described in this section are for technically competent users only. Do not change these values unless you completely understand the consequences of your changes. Bank 0/1 to Bank 6/7 DRAM Timing DRAM Clock Settings depend on type of memory installed, and therefore these settings are reserved. [Default settings are 5/10ns] DRAM Clock cycle timing. [Default is HOST-CLK] SDRAM Cycle Length Sets the CAS latency timing. [Default setting is 3] Allows for memory bank interleaving. [Default is Disabled] Bank Interleave Memory Hole Specifies the location of an area or memory that cannot be addressed on the ISA bus. [. . . ] It is fast enough to support video transfer, and is capable of supporting up to 127 daisy-chained peripheral devices. VGA (Video Graphics Array): the PC video display standard. V-SYNC: controls the vertical properties of the monitor. ZIF socket (Zero Insertion Force socket): these sockets make it possible to insert CPUs without damaging the sensitive CPU pins. The CPU is lightly placed in an open ZIF socket, and the metal level is pulled down. This shifts the processor over and down, guiding it into place on the board. 54 http://www. tyan. com Technical Support If a problem arises with your system, you should turn to your dealer for help first. Your system has most likely been configured by them, and they should have the best idea of what hardware and software your system contains. [. . . ]