User manual TYAN TOMCAT I875PF

[. . . ] Tomcat i875PF S5105 User's Manual Tomcat i875PF /// Revision 1. 00 S5105 Copyright © TYAN Computer Corporation, 2003. No part of this manual may be reproduced or translated without prior written consent from TYAN Computer Corp. All registered and unregistered trademarks and company names contained in this manual are property of their respective owners including, but not limited to the following. TYAN, Tomcat, i875PF and S5105 are trademarks of TYAN Computer Corporation. [. . . ] The password typed now will clear any previously entered password from CMOS memory. You will be asked to confirm the password. Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a password. To disable a password, just press <Enter> when you are prompted to enter the password. A message will confirm the password will be disabled. Once the password is disabled, the system will boot and you can enter Setup freely. When a password has been enabled, you will be prompted to enter it every time you try to enter Setup. This prevents an unauthorized person from changing any part of your system configuration. Additionally, when a password is enabled, you can also require the BIOS to request a password every time your system is rebooted. This would prevent unauthorized use of your computer. You determine when the password is required within the BIOS Features Setup Menu and its Security option (see Section 3). If the Security option is set to "System", the password will be required both at boot and at entry to Setup. If set to "Setup", prompting only occurs when trying to enter Setup. 3. 13 ­ Exit Selecting Phoenix ­ AwardBIOS CMOS Setup Utility Standard CMOS Features Advanced BIOS Features Advanced Chipset Features Integrated Peripherals Power Management Setup PnP/PCI Configurations Enter Password: PC Health Status Esc: Quit F10: Save & Exit Setup Frequency/Voltage Control Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor Password Set User Password Save & Exit Setup Exit Without Saving : Select Item Change/Set/Disable Password Save & Exit Setup Pressing <Enter> on this item asks for confirmation: Save to CMOS and EXIT (Y/N)?Y 46 http://www. tyan. com Tomcat i875PF S5105 Chapter 3: BIOS Setup Pressing "Y" stores the selections made in the menus in CMOS ­ a special section of memory that stays on after you turn your system off. The next time you boot your computer, the BIOS configures your system according to the Setup selections stored in CMOS. After saving the values the system is restarted again. Exit Without Saving Phoenix ­ AwardBIOS CMOS Setup Utility Standard CMOS Features Advanced BIOS Features Advanced Chipset Features Integrated Peripherals Power Management Setup PC Health Status Esc: Quit F10: Save & Exit Setup Frequency/Voltage Control Load Fail-Safe Defaults Load Optimized Defaults Set Supervisor Password Set User Password Exit Without Saving : Select Item Save Data to CMOS PnP/PCI Configurations SAVE to CMOS and EXIT Save & Exit Setup (Y/N)?N Pressing <Enter> on this item asks for confirmation: Quit without saving (Y/N)?Y This allows you to exit Setup without storing in CMOS any change. The previous selections remain in effect. This exits the Setup utility and restarts your computer. 47 http://www. tyan. com Tomcat i875PF S5105 Chapter 4: SATA/RAID Setup Chapter 4: SATA/RAID Setup The motherboard supports Intel® RAID 0 or 1for Serial ATA drives through the Intel® ICH5-R chipset. [. . . ] Tyan SMDC is compatible with all IPMI-compliance software as well as Tyan System TM Operator (TSO) software package. By adding SMDC, Tyan's server board becomes a highly manageable and IPMI compatible system with all the advanced features suggesting in IPMI Spec. More detailed information on Tyan's SMDC card can be found on our website: http://www. tyan. com 74 http://www. tyan. com Tomcat i875PF S5105 Technical Support Technical Support If a problem arises with your system, you should turn to your dealer for help first. Your system has most likely been configured by them, and they should have the best idea of what hardware and software your system contains. [. . . ]