User manual UFREE SCOOTER ELECTRIC SCOOTER FS-E20C

[. . . ] The Scooter has a 2-stroke engine that requires oil to be mixed with the petrol. Please use high quality 2-stroke oil. OIL AND FUEL MIXTURE INSTRUCTIONS For proper engine operation and maximum reliability, pay strict attention to the oil and fuel mixing instructions. Fuel/oil ratio should be at 25: l£¬ and by not using this ratio correctly damage can be caused to the engine. The following method will ensure complete mixing: ( I ) put a little fresh petrol into a clean 2. 5 liter fuel can; (II) add 0. 1 liter of 2-stroke oil; (III)fill the remainder of the fuel can with petrol; (IV)screw the fuel cap tightly and SHAKE the can for 30 seconds to mix the solution. FUELLING AND PRE-OPERATIONAL PROCESS (a)Petrol is extremely flammable and its vapours can explode so be sure to stop the engine and make it cool before fuelling. [. . . ] The left hand lever controls the rear wheel brake. The right hand lever controls the engine throttle. The red button can shut down the engine. Moving the handle with both hands, you steer the Scooter just like a bicycle. 3 UFREE SCOOTER www. scooter-manufacturer. com NOTES BEFORE you ride, thoroughly inspect the machine to ensure that no parts are loose or damaged. Do not use it until adjustments or repairs have been made. New engine break-in period is a couple of hours and avoid full throttle operation during this period. Position your feet in a comfortable location and balance your body with the left leg slightly behind the right leg and bearing most of your weight, lean back slightly and your Scooter will move like the smoothness of water skiing!When you accelerate or climb hills you will need to lean forward to keep the front wheel on the ground. When sudden brakes occur you will need to lean to keep the rear wheel on the ground. These parts are extremely hot after operation and remain hot for a short time after the equipment is turned off. PLEASE INJECT LUBRICATING OIL INTO THE OIL HOLE LOCATED IN THE TOP OF THE PLASTIC CHAIN COVER TO PROTECT THE CHAIN BEFORE YOU RUN THE ENGINE. SAFETY DRIVING Although the engine noise has been reduced, it is difficult to hear approaching vehicles so you must take care before turning. The rider has been designed to operate on any dry, hard and smooth surfaces. Wet, oily and uneven surfaces should be avoided at all times. STARTING BEFORE riding, you should start the engine firstly by pulling the "pull start" lead, with one foot placed on the deck. This may require a few "pulls" to get the engine started. When the engine has started you may accelerate slightly and at the same time place your other foot onto the deck. This process may need practice at first until you have mastered your balance. 4 UFREE SCOOTER www. scooter-manufacturer. com OPTIONAL SEAT The seat can be used on the Scooter once the rod has been put through the frame and through the seat column. The locking pin must then be clipped into position before riding. MAINTENANCE AND PARTS Only use the manufacture's original parts when repairing this unit. All frame parts are available through the distributors. [. . . ] WARNING: when putting on the fuse, please make sure the power key switch turns to OFF. Find the proper position, put the screw on and the tight the screw tightly. (Fig 5) Install of the mirror: put the socket on the proper position of the handle bar. Use the screw at the end of the handle mirror to tight up and fixed the mirror position. [. . . ]