User manual UFREE SCOOTER POCKET BIKE PB-G04WA

[. . . ] UFREE SPORTS VEHICLE www. scooter-manufacturer. com USER MANUAL Pocket Bike (Mini Moto) PB-G04 With Water-Cooled / Air-Cooled Engine. WATER-COOLED MINI MOTO PB-G04 SERVICE MANUAL FOR USE AND MAINTENANCE AND SPARE PARTS LIST For your own safety and the safety of others Follow these recommendations in order to use your MINIBIKE safely and correctly. Read the instructions CAREFULLY, failure to do so may place yourself and others in extreme and or ultimate DANGER. If you do not understand the instructions and Data then, you are not to attempt to operate this Minibike under any circumstances. It may be used for show purposes only! CONTENTS PAGE INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] It is not allowed to pull the starting wire up to full winding off. The choke lever will turn back to the position "A" automaticaly by turning the accelerating lever after a short engine run . Leave the minibike on the stand with running engine and if necessary adjust the revolutions so the rear wheel is not turning. For adjustment use the adjustment screw No. Float chamber A ­ Cock position for riding C ­ Cock position for cold starting 3 Fig. 3 4 RIDING Remove the minibike from the stand to sit on the seat. When seated, then slowly rotate the throttle grip to start riding. Before braking, rotate the Throttle grip to the off or idle position and lightly depress the rear brake lever with left hand and then the front brake lever with right hand. The minibike engine is switched off by pushing the red button (Engine stop switch) on the handlebars. It is necessary to check the tightness of bolts and nuts, especially of the engine, and the brake settings after the first ride and often during the break in period. PERIODIC MAINTENANCE Periodic maintenance is the best way to help the machine perform well, give longevity and provide safety and low cost operation. In addition, you will be spared from many worries from self caused problems, resulting from poor maintinence or no maintinence. Check the Cables and efficiency of brakes. Check the lubrication and chain tension settings. The chain free play should be (5 mm) (. 200in) After every ride clean the minibike carefully and keep it clean. Do not use aggressive cleaning detergents. After 1-hour of use, wash the air filter in air drying spirits and lubricate it with special oil for air filters. After 1- hour of use, check the state of the clutch pads. After every 5 hours of riding: Check the tightness of all bolts and nuts. Tighten with a properly adjusted torque wrench only!For torque settings see tables on page 17. Wash the air filter in gas and lubricate it with special oil for an air filters to better catch the dust. Clean carefully the carburetor float chamber. [. . . ] The same procedure applies to the venting hose (P/N 349. ) between the cylinder head and the radiator. Once more vent the system while loosening the air bleed screws until all air is expelled. Close the tank and pull the start T'handle two or three times. This will circulate the coolent in the system. [. . . ]