User manual ULINE ECHELON 2075R

[. . . ] É c h e l o nTM TM U S E R M A N U A L U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Line's option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, U-Line shall:. (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. [. . . ] Turn the knob clockwise for ON, counterclockwise for OFF. Models 2015R, 2075R and 2075RF turn OFF when the temperature control is turned counterclockwise all the way toward warmer until it stops (until "click" is heard). 16 4 3 2 1 WARMER 5 6 7 COLDER UL315 Figure 20 CONTROL SETTINGS - COMBO/ICE MAKER TEMPERATURE CONTROL KNOB Models BI 2015 and 2075FF are turned ON with the ON/OFF switch recessed in the front grille (see Figure 21). In these units, the control dial is used only for temperature control. 4 3 2 1 WARMER 5 6 7 COLDER OFF ON ON/OFF SWITCH UL316B Figure 21 1. Plug the appliance cord into a 115V polarized and grounded electrical outlet. All units are shipped in the ON position. Open the water supply valve in the main water source. As soon as the ice maker mold reaches the proper temperature, the ice maker mechanism will fill the mold with water. The first cubes may be small because of air in the water line. Subsequent cubes will be of standard size. Allow 2 hours for frost free models. It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first two to three hours of operation. 17 User's Manual NORMAL OPERATION On units with refrigerator sections, the unit has been designed to achieve a fresh food temperature of approximately 38°F. Those units with a freezer section are designed to have a freezer temperature of approximately 0°F. On units with ice makers, when the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the cube supply. Frost free icemaker units have lower ice production than manual defrost units. Ice production may be interrupted by raising the bin arm into an upright and locked position (the unit will maintain temperature for ice storage, see Figure 22). UL002A Figure 22 Certain sounds are normal during the unit's operation. You may hear the compressor or fan motor, the water valve, sounds of defrost, or ice dropping into the ice bucket. !WARNING NEVER use an ice pick, knife, or other sharp instrument to separate cubes. The ice bucket MUST be fully inserted to avoid freezing products in the refrigerator section of the Combo 2075FF. During periods of limited usage or high ambient temperatures, it is common for cubes to fuse together. If ice maker is not used regularly, the ice bucket should be emptied periodically to ensure fresh cubes. [. . . ] If the problem persists, check the TROUBLESHOOTING GUIDE. Locate the problem in the guide and refer to the cause and its remedy before calling for service. The problem could be something very simple which can be solved without a service call. TROUBLESHOOTING GUIDE !DANGER ! ELECTROCUTION HAZARD NEVER attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting -- What to check when problems occur Problem No interior light. [. . . ]