User manual ULINE ECHELON 2115R

[. . . ] Use and Care Guide Refrigerator Models: 2115R, 2175R 2115R 2175R 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world's number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. [. . . ] · Rust that is not cleaned up promptly can penetrate into the surface of the stainless steel and complete removal of the rust may not be possible. Defrosting Frost-Free Models Frost-free models do not produce frost in normal operating conditions. However, a frost pattern may be noticed on the interior walls if the unit is repeatedly opened in a high heat or high humidity location. If this frost pattern does not clear within 24 hours, your unit will require manual defrosting. WARNING DO NOT use any type of electrical heating device, ice pick, knife or other sharp instrument to defrost; this could damage the inner lining or refrigeration system and void the warranty. IMPORTANT The drain pan was not designed to capture the water created when manually defrosting. To prevent water from overflowing the drain pan, place towels or other absorbent materials over the interior drain trough, under the evaporator (Figure 8, 1), before defrosting. 1 Interior Cleaning (As Required) · Disconnect power to the unit. Clean the interior and all removed components using a mild non-abrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. Rinse the interior using a soft sponge and clean water. · Do not use any solvent-based or abrasive cleaners. These types of cleaners may transmit taste to the interior products and damage or discolor the interior. Figure 8 ULIN_0186_A 10 2115R, 2175R To defrost: 1. Remove all products from the interior and prop the door in an open position (2 in. Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild nonabrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. NOTE: DO NOT use any solvent-based or abrasive cleaners. They will discolor or damage the interior. Dampen a soft sponge or non-abrasive cloth in clean water and wipe down the cabinet interior and removed components to remove any detergent residue. Rinse the sponge or cloth in clean water and repeat as necessary until the cabinet and components are clean. When the interior is dry, turn unit back on. CAUTION DO NOT use any type of cleaner on the condenser unit. Clean the condenser coil (Figure 9, 2) using a soft brush with a "combing" action or vacuum cleaner. Position the grille to align the mounting screws with the holes in the cabinet. Secure, but do not over-tighten both grille screws. Reconnect power to the unit. Leveling Condenser Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. 1 WARNING Disconnect electric power to the unit before cleaning the condenser. [. . . ] Ice maker will automatically turn back on in three hours. Hold Hold NOTE: 38°F is an example; the display will vary with actual set-point. IMPORTANT Factory recommended set-point is 38°F for refrigerators and beverage centers, and 50°F for wine coolers. 18 2115R, 2175R U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Lines option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, ULine shall: (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. [. . . ]