User manual ULINE ORIGINS 1175BEV

[. . . ] Use and Care Guide Refrigerator Models: 1115R, 1175R, 29R Beverage Center Model: 1175BEV 29R 1175BEV 1115R 1175R 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world's number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. [. . . ] Rinse the interior using a soft sponge and clean water. Figure 10 ULIN_0196_A 1115R, 1175R, 29R, 1175BEV 13 To defrost: 1. Remove all products from the interior and prop the door in an open position (2 in. Allow the frost to completely melt naturally. Clean the interior and all removed components using a mild nonabrasive detergent and warm water solution applied with a soft sponge or non-abrasive cloth. NOTE: DO NOT use any solvent-based or abrasive cleaners. They will discolor or damage the interior. Dampen a soft sponge or non-abrasive cloth in clean water and wipe down the cabinet interior and removed components to remove any detergent residue. Rinse the sponge or cloth in clean water and repeat as necessary until the cabinet and components are clean. When the interior is dry, turn unit on. 4. Remove grille and grille cap from unit. 1 ULIN_0153_A Figure 12 5. Clean the condenser coil (Figure 12, 1) using a using a soft brush with a "combing" action or vacuum cleaner. Do not touch the condenser coil. Condenser Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. 2 1 Figure 13 6. Make sure grille cap is behind grille in slots provided in grille (Figure 13, 1) before attaching grille to unit, and secure but do not overtighten both grille screws (Figure 13, 2). Reinstall the control knob (Figure 11, 1). Reconnect power to the unit. ULIN_0198_A WARNING Disconnect electric power to the unit before cleaning the condenser. WARNING DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. Model 1115R IMPORTANT DO NOT use any type of cleaner on the condenser unit. Disconnect power to the unit. 1 Model 29R 1. Disconnect power to the unit. 2 3 2 ULIN_0155_A Figure 14 2. Loosen the two screws (Figure 14, 1) completely. 1 ULIN_0197_A NOTE: Screws are held in the grille by o-ring retainers, and will not come free of the grille. Remove grille (Figure 14, 2) and grille cap (Figure 14, 3) from unit. Figure 11 2. [. . . ] Repeat to switch back. NOTE: 38°F is an example; the display will vary with actual set-point. IMPORTANT Factory recommended set-point is 38°F for refrigerators and beverage centers, and 50°F for wine coolers. 1115R, 1175R, 29R, 1175BEV 27 This page intentionally left blank 28 1115R, 1175R, 29R, 1175BEV This page intentionally left blank 1115R, 1175R, 29R, 1175BEV 29 This page intentionally left blank 30 1115R, 1175R, 29R, 1175BEV U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Lines option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, ULine shall: (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. [. . . ]