User manual ULTIMATE SPEED KH 3017 HYDRAULIC CAR JACK

[. . . ] Before each use check that the hydraulic vehicle jack is working properly. Check the screws and valves of the hydraulic vehicle jack for correct seating and look out for hydraulic oil leaks in particular. [. . . ] The following is / are forbidden: - Operation under difficult conditions - Operation that is subject to special provisions - The handling of loads whose properties could lead to dangerous situations - Dangers that arise during dismantling - Direct contact with food - Operation on ocean-going vessels Follow the instructions below to avoid the threat of loss of life, injury, or damage to the product etc. J Always use axle stands and wheel chocks in addition to your hy- 1 Hydraulic car jack 2 Tube sections with locating slot 1 Tube section with locating pin 1 Operating instructions Never work under a raised vehicle unless you have taken additional safety precautions. This is intended to prevent the vehicle from rolling away, sliding off or overturning the jack. the product on a solid , level surface only. Using the product Use on an unstable or uneven surface ­ such as a gravel surface ­ may lead to the load slipping. Ensure that you never exceed the allowable (rated) load capacity. Person operating the jack must observe the jack and the load The during all movements. Never work under the raised load if it has not been made secure by suitable means. Follow these steps: j lace one of the tube sections with a locating slot 6 on to the P release valve 5 and turn it in the direction (see Fig. j ow assemble the three-part pumping lever 8 . Turn each tube N section 6 7 in the direction to fix it in place. j lace the hydraulic vehicle jack under one of the lifting positions as P shown in the owner's manual supplied by the vehicle manufacturer. [. . . ] O J nly the appropriate service centre is allowed to replace spare O J n all cases of malfunction or necessary repairs, contact the servI Parts and/or carry out repairs. Enquire at your city council or local government regarding the possibilities of disposing of old oil and hydraulic oil as well as the disused product in a correct and environmentally friendly way. [. . . ]