User manual ULTIMATE SPEED T4X SE / KH 3033 BATTERY CHARGER

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Watts (Effective power) Volt (AC) Safety class II Keep children away from electrical devices!Check that the device, mains lead and plug are in good condition! [. . . ] Otherwise damage to property could occur. Before connecting the charging station, read the information on battery maintenance in the operating instructions of the battery!Otherwise personal injury and / or damage to the device could occur. Before connecting the charging station to a battery permanently installed in a vehicle, read the information on electrical safety and maintenance in the operating instuctions of the vehicle!Otherwise personal injury and / or damage to the device could occur. Unplug the charger from the mains supply when not being used!Remain alert at all times and always watch what you are doing. Always proceed with caution And do not use the battery charger if you cannot concentrate or feel unwell. This appliance has been designed for charging a variety of SLA batteries (sealed lead acid batteries), as mainly used in cars, motorbikes and several other vehicles. A special design of the appliance (also named , , three-phase-charging strategy") enables the recharging of the batttery to almost 100 % of its original capacity. Connecting the battery for a long period to the battery charger is also a good way of ensuring that your battery is kept in optimum condition. Then disconect the plus pole connecting cable (red) of the vehicle from the plus pole of the battery. Connect the mains lead 11 of the battery charger to an electrical power outlet socket. Disconnect the appliance from the power supply. Before you carry out any work on the battery charger always pull the mains plug out of the mains socket. Ensure that you do not strike electrical cables, gas or water pipes when you are drilling into the wall. If necessary, check the wall using a suitable detector before you drill. You may find it convenient to attach the battery charger on to a board or a wall. Screw the two screws through the mounting holes 12 into the board or wall. Before starting the charging or discharging procedure on a permanently installed battery in a vehicle, first disconnect the minus pole connecting cable (black) of the vehicle from the minus pole of the battery. You can select different charging modes for charging different batteries at different ambient temperatures. In comparison with conventional battery charging stations, this appliance has a special function for reusing an empty battery or rechargeable battery. [. . . ] As soon as this point is reached, the battery charger switches to maintenance charging mode. Now the LED indicator 8 goes out and the LED indicator 7 lights up to indicate the present status. If the appliance becomes too hot during charging, the power output is automatically reduced. This protects the appliance from damage. [. . . ]