User manual ULTIMATE SPEED UPA 500 A1

[. . . ] Pay heed to the instructions in this warning to avoid personal injuries. TAKE NOTE A warning at this risk level signifies potential property damage. If the situation is not avoided it could lead to property damage. Pay heed to the instructions in this warning to avoid property damage. [. . . ] Slide the battery compartment cover in the direction of the arrow and remove it from the appliance. Pay heed the the polarity markings given in the battery compartment 6 . replace the battery compartment cover and let it firmly engage. NOTICE If, during use or in standby mode, the red LED 3 flashes once every 10 seconds, the batteries are too weak and must be replaced. DANGER When drilling the holes ensure that any electric cables or other installations in the wall, such as water pipes, are not damaged. tAKE NOTE The supplied plugs are only suitable for a mounting on concrete or stone. Before starting the installation, please check your installation location carefully for its suitability for the plugs. On the garage wall at the level of Attach the Parking Lamp the windshield of your vehicle. For this, mark two boreholes with a vertical spacing of 130 mm. Attach the ultrasonic sensor on the garage wall at the level of the bumper of your vehicle. For this, mark two boreholes with a vertical spacing of 45 mm. Now bore, using an electric or hand drill fitted with a 6 mm drill, the four holes to a minimum depth of 30 mm. Insert the plugs into the holes and screw the screws in. Leave the screw heads protruding a little. now hang the Parking Lamp and the ultrasonic sensor 7 on the screws. NOTICE Alternatively, you can also use the supplied hook and loop and the ultrasonic pads for mounting the Parking Lamp sensor 7 . The appliance has three operating modes: Standby The appliance switches automatically into standby mode (energy saving mode) if no movement has occurred within the monitoring area for about 30 seconds. in the case of movement occuring , the appliance automatically detects the entrance or exit , and switches itself on again. Entrance On entrance into the garage the appliance switches itself on with the light sequence green - yellow - red. Exit Should a vehicle remove itself from close to the appliance, the yellow LED 4 switches on and then the green LED 5 . The appliance is now operational and the green LED 5 glows permanently. Now test the functionality by moving slowly towards the ultrasonic sensor 7 and checking the individual light signals of the Parking Lamp . [. . . ] Only in this way can a post-free despatch for your goods be assured. NOTICE The warranty covers only claims for material and manufacturing defects, not for transport damages, wearing parts or for damage to fragile components, e. This appliance is intended solely for domestic, not commercial, use. In the event of misuse and improper handling, use of force and interference not carried out by our authorised service branch, the warranty will become void. [. . . ]