User manual UMAX XTREAMER COOLER FITTING INSTRUCTIONS

[. . . ] Page 4 N E A R LY D O N E Fitting Heatsink You are now ready to fit the XSC heat sink. Please look at the heat sink and fitting area. [. . . ] When the Xtreamer is turned on, you should notice that the XSC heat sink becomes slightly warm, this means it is working correctly. If after a few hours of use, the heat sink is not warm, the new cooler has not been fitted correctly ­ unplug the Xtreamer and check that the heat sink is in line with the plastic on all four sides The Xtreamer base can still be used safely. The Xtreamer should be used on its stand (vertical) or on its side (horizontal) with the XSC heat sink to the top. If these instructions are followed correctly, then your warranty is still valid. brought to you by TRANQUIL PC LIMITED XTREAMER COOLER FITTING INSTRUCTIONS Thank you for your purchase of the Xtreamer Side Cooler The cool silent solution Enjoy your new silent Xtreamer !Tranquil PC Limited http://www. tranquilpc. co. uk Tranquil PC Limited http://www. tranquilpc. co. uk See Us at http://www. thextreamer. com Contact Us at sales@thextreamer. com See Us at http://www. thextreamer. com Contact Us at sales@thextreamer. com Page 2 Page 3 FITTING INSTRUCTIONS The fitting of the XSC will remove the need for the use of the fan in the Xtreamer. The process of upgrading the cooler is simple, but we do recommend that this short instruction guide is completely read before starting. Once completed, you should turn OFF the fan in the MISCL menu of the Xtreamer setup screen. Also you will want to set the fan to 0/50 if you are running the Xtreamer in NAS mode. To complete the upgrade, you will require all components in this kit and a small flat bladed screwdriver, or kitchen knife (take care, always point any sharp objects away from you when in use). FITTING INSTRUCTIONS Removing the SIDE plate and INNER heat sink (cont. ) Lever back the plastic edge of the Xtreamer case where shown in the figure. Remove the inner (silver) heat sink completely. Once removed you will see the main chip, with a little white Thermal Interface Material (TIM) on the surface. Please dispose of the original side plate and the inner heat sink responsibly. Removing the SIDE plate and INNER heat sink Firstly place your Xtreamer on a flat surface, with the side displaying the A/V connector details facing downwards, as show in the diagram below. [. . . ] Also remove all surplus sticky tape left on the on the flat plastic surfaces marked B in the diagram. If there are any pieces of tape left over, the new XSC will not fit in place correctly, neither will you be able to practice fit the XSC. XSC FITTING V1. 0EN (SEPT 2009) TRANQUIL PC LIMITED [. . . ]