User manual UNIDEN ALP 9080

[. . . ] 1-Line Alpha/Numeric Pager Operating Guide UPZZ01659ZZ FCC Information Your pager might cause TV or radio interference even when it is operating properly. To determine whether your pager is causing the interference, turn it off. If the interference goes away, your pager is causing the interference. Try to eliminate the interference by moving the pager away from the receiver. [. . . ] To cycle through the alert types, press f or k. To store your selection in memory, press N. To toggle between Auto Reset (alert tone stops after 8 seconds) and Non-stop (alert tone sounds until you press any key), press f or k. The Silent alert does not use the Auto Reset or Non-stop options. To store your selection in memory, press N. The standby display returns showing the audio alert symbol (a). 13 Using the Alarms You can set the pager to sound an audible or vibrate alarm at the same time every day, and/or at a specific time on a certain date. When a set alarm time arrives ­ even if the pager is turned off ­ the pager repeatedly sounds a unique alert tone (different than any message alert tone pattern) or vibrates for about 20 seconds. To stop the alarm sooner, press any key. t The bell icon appears in the display when you turn on any one of the two alarms (daily and/or date). t The bell icon disappears from the display only when both alarms are turned off. 14 Setting a Time Alarm To set an alarm for a specific time every day: Example: Every day at 5:54 p. m. From the standby display, go to Time Alarm (as shown): 1. To set the alarm on or off, press f or k. To select the hour, press f or k until you reach the hour you want. To store your selection and move to the minutes display, press N. To set the minutes, press f or k until you reach the minute you want. To set the alarm alert type (AUDIO ALARM or VIB ALARM), press f or k. To store your selection in memory, press N. 15 Setting the Date Alarm To set an alarm for a specific date and time: Example: February 14, at 5:54 p. m. From the standby display, go to Date Alarm (as shown). To set the alarm on or off, press f or k. To select the month, repeatedly press f or k. [. . . ] 29 Deleting Individual Personal Messages Go to the message that you want to delete (as shown below). 1. To cancel (not delete the message), press O (escape/cancel). After about 2 seconds, the standby display appears. 30 Deleting All Messages From the standby display, go to Delete All (as shown): 1 Press N. The confirmation message "DELETE OK?" displays. T To Cancel the delete, press O, f or k. 3. [. . . ]