Detailed instructions for use are in the User's Guide.
[. . . ] 4, 932, 074 5, 428, 826 5, 483, 684 5, 577, 076 5, 896, 422 6, 034, 573
patent: 4, 947, 456 5, 438, 688 5, 530, 296 5, 598, 430 5, 991, 346 6, 064, 270
** U. S. Patent Number 4, 841, 302 is licensed from Gray Electronics, Inc. ** These products contain Uniden proprietary information. Software, control codes, protocols and other such related matter may be the copyrighted work of Uniden America Corporation. [. . . ] If that frequency is interesting to you, press [HOLD] to hold the frequency in the display. Then program it into one of the programmable banks (Private, Police or Fire/EMS). If you do not want to program that frequency, press [SEARCH] or just wait untill the transmission ends. The search resumes automatically 2 seconds after the last transmission and looks for more active frequencies. PRIVATE Bank Scanning If you have programmed frequencies into this bank, press [PRIVATE] to scan only those that you have programmed in this bank. Note: Before you can scan the Private bank, you must program frequencies into the channels. To program frequencies, see "Programming Frequencies" on page 24. When scanning stops on an active frequency, it remains on that channel as long as the transmission continues. When the transmission ends, the scanner will remain on the same channel for 2 more seconds, waiting for a responding transmission. If there is no responding transmission within 2 seconds, the scanning cycle resumes.
Getting Started
The following instructions apply when using your BC3000XLT (except for in the Program mode) for the very first time. Each time you turn on the scanner, it always retains the previous settings in its memory. (Or, you can press [SEARCH] to start searching. ) In the Scan/Hold Mode, each time you press [UP] or [DOWN], you step up or down one channel at a time (one frequency step each for the AIR bank). To rapidly step through that bank, press and hold [UP] or [DOWN]. In the Scan/Hold Mode, you do not skip a locked out (L/O) channel using [UP] or [DOWN]. While scanning and the scanner stops on an active channel that you do not want to monitor, but you do not want to lock out, you can simply press the bank key: [PRIVATE], [POLICE], [FIRE/EMS], [WX], or [CB] again or [UP]. Notes: · To resume scanning while in the Marine or Aircraft mode, you can only press [UP]. Pressing the bank key again will switch you from Marine to Air or Air to Marine. · Before you can scan the Private bank, you must program the channels.
Weather Channel Scan
The BC3000XLT allows you to search for your local NOAA weather channel. Press [WX] to find the active weather channel in your area from 10 pre-programmed channels. To exit Weather Mode, press any other bank key or [SEARCH]. It is possible that your area is covered by more than one weather station. When you press [WX], the BC3000XLT will find an active broadcast immediately. [. . . ] Scan won't stop · Check and adjust Squelch (see "Adjusting the Squelch" on page 18). · Check to see if all channels are locked out. · It is possible that none of the programmed frequencies are active at the time. Try the band search.
30
UB317Z (BC3000XLT) 0916
9/16/03
12:43 PM
Page 31
PROBLEM Scan won't start
PROBLEM · Press the bank key again. [. . . ]
