User manual UNIDEN BC60XLT OPERATING GUIDE

[. . . ] Using another charger may damage the Batteries, or cause them to explode. n properly. Read the Nickel-Cadmium Battery Disposal package insert for important information. ALKALINE BATTERY WARNING · Nickel-Cadmium Batteries must be disposed of · Do not recharge Alkaline Batteries in this product. Doing so may cause serious damage to the product and will void the warranty. Alkaline Batteries in this product. · Uniden does not recommend using rechargeable Controls 1. [. . . ] You could damage the case or clip. 7 Operation Keylock Keylock prevents accidental key entries. To lock: S M, K Only the , and keys will function. To unlock: If keys do not work, press to unlock keys. K The K/L indicator disappears from the display. 8 Programming Channels 1. Select channel using Manual mode. Note: For channel 10, , . Enter frequency. Each digit displays as you enter it. The decimal displays as a dash. If you make a mistake, twice and start press over. . 3a. If frequency outside range. Programmed frequencies must be within the bands shown on the back of the scanner, and on page three of this guide. 10 4. Recheck frequency. The frequency appears one digit at a time in sequence. Repeat these steps to program each channel. You can program the same frequency into two or more channels, if desired. Channels with no frequency programmed are skipped during scanning. After programming your scanner, record the frequencies in the table below (or another convenient place) so you can easily reprogram the scanner in case the memory is accidentally erased. Use pencil so you can change your entries at a later date. Channel 1 2 3 4 5 6 7 8 9 10 Frequency Notes 11 How Squelch Works Think of "SQUELCH" as a gate. If the gate is set too low (SQUELCH too low), everything (all noise as well as signals) gets through. If the gate is set too high (SQUELCH too high), nothing gets through. If the gate is set just right (SQUELCH set properly), just the desired signals get through. 12 Setting the Squelch 1. Turn until hiss heard. This action lowers the "squelch gate, " allowing all signals and noise to get through. No signal should be present when adjusting squelch. Scanner doesn't scan with squelch open. 2. Turn just until hiss stops. This action raises the "squelch gate, " allowing only strong signals to get through. Scanner should begin scanning after two seconds. Note: You must have at least one channel programmed before the BC60XLT will scan. Scanning Programmed Channels Turn the scanner on. Channel numbers advance rapidly. Note: When you turn the scanner on, it will always be in Scan mode. 13 The scanner skips any unprogrammed channels, and locked out channels. When transmission received: Scanner stops on that channel. When the transmission ends, scanning resumes after a two second delay. To hold on that channel: 14 To resume scanning: Scanner immediately resumes scanning. To listen to or program a specific channel: Note: For channel 10, , . press 10 to resume Press scanning. S 15 Channel Lockout Channel Lockout lets you skip channels during scanning. There are two ways to lock out a channel: Manual Mode Use Manual mode to select the channel you want to lock out. Note: For channel 10, , . press 10 16 Scanning Mode When the scanner stops on a channel during scanning, you can lock out that channel by . [. . . ] THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America. [. . . ]