User manual UNIDEN DCX700

[. . . ] Connect the charger and charge your new handset for 15-20 hours. Register your new handset to the main base. Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove. Plug the battery pack connector (red & black wires) into the jack inside the battery compartment. [. . . ] 2)While holding find handset (or intercom for DCT6485 models), connect the AC adapter. Keep pressing the key until the CHARGE LED starts to blink. 3)On the handset, press and hold # until you hear beep. 3 While the handset is registering, Ha nd s et Re g is t er in g will appear in the handset LCD. When Re g is t ra ti o n C om p le te is displayed, the handset has been registered to the base. If R eg is t ra t io n F a il ed appears, please try these steps again. ­4­ UU869BH_TCX700 OM. fm Page 5 Wednesday, June 2, 2004 10:46 AM Using Your Expansion Handset Now that your new handset is registered, it can perform all the same functions as the handsets originally included with your phone. With your new handset, you can · Transfer calls or intercom between handsets and base (depending on model) · Use two handsets as 2-way radios in DirectLink mode · Use two handsets as a baby/room monitor · Hold 3 or 4-way conference calls (depending on model) · Access your main base's integrated answering device (if available) · Access voice mail using handsets or main base (depending on model) See the owner's manual that came with your main base for complete instructions on operating your new expanded digital phone. Battery Information Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The batteries need to be charged when: - The empty battery icon appears. - L ow B a tt e ry appears in the display. If the phone is in standby mode, none of the keys will operate. If you are on a call, complete your conversation as quickly as possible, and return the handset to the charging cradle. Cleaning the battery charging contacts To maintain a good charge, it is important to clean the charging contacts on the handset once a month. Using water only, dampen a cloth to clean the charging contacts. Then make sure to go back over the charging contacts with a dry cloth before returning the handset to the charger to charge. Caution: Do not use paint thinner, benzene, alcohol, or other chemical products. Doing so may discolor the surface of the telephone and damage the finish. ­5­ UU869BH_TCX700 OM. fm Page 6 Wednesday, June 2, 2004 10:46 AM I. C. Notice TERMINAL EQUIPMENT NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. NOTICE: The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. RADIO EQUIPMENT The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. [. . . ] Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America and Canada. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). [. . . ]