User manual UNIDEN EX945

[. . . ] Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Use a dry cloth for cleaning without liquid or aerosol cleaners. Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. [. . . ] Plug the AC Adapter into a standard 120 VAC wall outlet. T Do not use an outlet controlled by a wall switch. Use only the Uniden AC Adapter supplied with this phone. EX 905/925 11 Wall Installation Standard Wall Plate Mounting These phones are designed to be mounted on a standard AT&T or GTE wall plate. Plug the AC Adapter into the Base Unit. 2. Place the AC Adapter cord around the strain relief notch. Then, put the AC Adapter cord inside the molded channel. 12 EX 905/925 3. Plug one end of the short telephone cord into the TEL LINE jack on the Base Unit. Place the telephone cord inside the molded channel on the bottom of the Base Unit. Then plug the other end of the telephone cord into the modular jack on the wall. 4. Place the Base Unit on the posts of the wall plate and push down until it's firmly seated. 5. Plug the AC Adapter into a standard 120 VAC wall outlet. T Do not use an outlet controlled by a wall switch. EX 905/925 13 Direct Wall Mounting If you do not have a standard wall plate, you can mount your phone directly on a wall. Before mounting your phone, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. · Make sure the wall material is capable of supporting the weight of the Base Unit and Handset. Complete your call as quickly as possible. Return the Handset to the Base Unit for charging. In Standby Mode None of the buttons will operate. The Handset talk · batt low LED flashes once every 3 seconds. Return the Handset to the Base Unit for charging. T Allow 15 to 20 hours without any interruption for the Handset to fully recharge. Setting the Pulse/Tone Switch Be sure the PULSE/TONE switch is in the TONE position. T Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing 20 EX 905/925 Adjusting Ringer Controls Ringer Tone and Volume While the phone is not in use, press ringer. The phone has two ringer tones with two volume levels one soft and one loud. Each time you press ringer, the ringer/volume changes. Receiver volume While you are on a call, press volume. The phone has two receiver volume levels - one soft and one loud. Each time you press volume, the receiver volume changes. EX 905/925 21 Automatic Digital Code Security To avoid unauthorized calls on your phone, a Digital Code was added to all EX 905/925 phones. This Digital Code is shared only between the Handset and Base Unit. [. . . ] This will prevent the battery from completely discharging. If the phone is desk/table top installed, make sure the Handset is in the vertical position and the contacts are touching. Hear only continuous static from Handset and phone will not turn off. · · · Handset does not fully charge. · EX 905/925 31 Specifications General ­ The EX 905/925 complies with FCC Parts 15 and 68. Frequency Control PLL Modulation FM Operating Temperature -10º to 50º C Base Unit Receive Frequency Transmit Frequency Power Requirements Size Weight 902. 10 to 905. 00 MHz (30 Channels) 925. 00 to 927. 90 MHz (30 Channels) 9 V 210 mA (from AC Adapter) 5-1/2 in. (W) x 2-1/2 in. [. . . ]