User manual UNIDEN EXAI918I

[. . . ] Precautions! Before you read anything else, please observe the following: Warning!Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture. Rechargeable Nickel-Cadmium Battery Warning H This equipment contains a Rechargeable Nickel-Cadmium Battery. H Cadmium is a chemical known to the state of California to cause cancer. [. . . ] To hang up, press speaker again. CH-10 CH-10 Note: If the Handset fails to connect with the Base Unit the Handset beeps and returns to standby mode. 3. Press redial/pause. CIDCW ON 1234567 Note: If the last number dialed is longer than 12 digits, the display will scroll to the left until the last number is shown in the display. 4. During your conversation the LCD displays the call timer. Note: Adjust the speakerphone volume by pressing L for louder or M for softer. Answering a Call with AutoTalk Enabled If you have enabled the AutoTalk feature, just remove the Handset from the Base Unit to answer an incoming call. See "Setting the AutoTalk Feature" on page 18 for details on setting AutoTalk. If the Handset is off the Base Unit, press any key to answer an incoming call. Answering a Call without AutoTalk Enabled When the phone rings, pick up the Handset and press talk. . The channel number is displayed for 2 seconds. During your conversation the LCD displays the call timer. CIDCW ON 00:00:01 5. When you have finished with the conversation, press talk to hang up. -- OR -- Place the Handset back on the Base Unit. CH-10 CH-10 Using the Flash Key with Call Waiting Note: You must subscribe to call waiting service from your local phone company to use this feature. CIDCW ON 00:00:01 1. While talking you hear the call waiting signal. KATHLEEN ROL 817-858-3333 CIDCW ON 00:00:01 When you are finished with the conversation, press talk to hang up. -- OR -- 2. Press flash/function to switch to that call. Place the Handset back on the Base Unit. To switch back to your original call, press flash/function again. 20 EXAI918 Using Caller ID The Caller ID Display The LCD displays information about the current call and previous calls received on your EXAI918 cordless phone, including the total calls received, and the number of new calls received. The LCD display backlight is always active while the Handset is on the Base. When the Handset is removed from the Base, the LCD display backlight turns off immediately. To reactivate the LCD backlight, you need to press caller id . LCD with Handset on Base NEW 02 NO NEW CALLS LCD with Handset off Base and Caller ID Pressed TOTAL 10 WITH NEW CALLS TOTAL CALLS 10 NO NEW CALLS NEW 02 TOTAL 10 WITH NEW CALLS Note: The EXAI918 can store information on up to 30 different calls. Information on new calls received after 30 calls will be stored, and the oldest call in memory will be deleted. Viewing Calls in Memory 1. The status LED blinks, indicating when you have received new calls. To dial the number currently displayed, press the talk key. To add a 1 for long distance dialing, press 1 and then press the talk key. Note: If the number is longer than 12 digits, the display will scroll to the left until the last number is shown in the display. 5. To see all calls stored in memory, press the L key repeatedly until the LCD displays END. 2. Press caller id. END 817-858-3333 TOTAL CALLS 10 KATHLEEN ROL 817-858-3333 6. [. . . ] Delete some or all of the saved messages. · The incoming messages may be too long. Remind callers to leave a brief message. Delete some or all of the saved messages. [. . . ]