User manual UNIDEN EXP2905

[. . . ] Precautions! Before you read anything else, please observe the following: Warning!Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture. Rechargeable Nickel-Cadmium Battery Warning · This equipment contains a rechargeable nickel-cadmium battery. [. . . ] · When the TALK/BATT LOW LED repeats a set of two flashes, the base phone is in use. · When you set the handset volume to H (high), the volume will be raised considerably. Under normal circumstances, set the volume to M (middle). 16 Basics If the handset battery becomes weak during a call You hear a beep every three seconds and the TALK/BATT LOW LED on the handset flashes. Replace the handset on the base phone to charge. For optimum performance, charge the battery for 15-20 hours. Note that during the first 10 - 15 minutes of charging, the phone will be inactive, i. e. , unable to make or receive a call. After this initial 10 - 15 minutes, you may be able to use the phone, but the battery duration will be very short; thus it is recommended that you fully charge the battery before the next usage. Basics Making calls through the speakerphone Press SPEAKER on the base phone. The SPEAKER LED and the LINE LED light up. When you are done talking, press SPEAKER again. REDIAL/P * TONE LINE LED FLASH HOLD VOLUME control SPEAKER SPEAKER LED Additional tasks Do this Press HOLD . Press SPEAKER to resume the conversation. Adjust the speaker volume Press VOL or VOL . TONE while using the telephone after Switch to tone dialing Press * temporarily you're connected. The line remains in tone dialing until disconnected. Switch to another call Press FLASH to access the flash function. ("call waiting" service*) Press FLASH again to return to the first caller. * You need to subscribe to the service from your telephone company. To Put a call on hold continued Basics 17 Making calls (continued) To obtain the best speakerphone performance · You may not be able to hear the other party's voice in a noisy place. Therefore, use the speakerphone in a quiet room. · Do not bring your hand or other object too close to the microphone or you will hear a shrill noise ("feedback"). · When the speaker volume is loud, or the telephone has been placed close to a wall, you may find that the volume drops suddenly. This is due to a circuit in the telephone designed to protect against feedback. In such cases, lower the speaker volume slightly. Redialing On the handset 1 Press TALK . [. . . ] · If the charge terminals of the base phone and handset are soiled, wipe them with a soft cloth. If you have any questions or problems concerning your phone, please call our customer hotline at 1-800-297-1023. 34 Additional Information Specifications General Frequency band 902 - 928 MHz Operating channel 40 channels Dial signal Tone, 10 PPS (pulse) selectable Supplied accessories See page 7. Base phone Power source DC 9V from AC power adapter AD-314 Dimensions Approx. 170 x 65 x 220 mm (w/h/d), antenna excluded (approx. 6 3/4 x 2 5/8 x 8 3/4 inches) Antenna: Approx. [. . . ]