User manual UNIDEN EXP4241

[. . . ] EXP 4241 Series OWNER'S MANUAL Introduction Uniden 2. 4GHz cordless phones are designed and engineered to exacting standards for reliability, long life, and outstanding performance. NOTE: Illustrations in this manual are used for explanation purposes. Some illustrations in this manual may differ from the actual unit. The color of your cordless phone may vary. [. . . ] In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code. 1) Remove the handset from the base unit. Press and hold the find hs key on the base. 2) While holding the find hs key, place the handset in the base unit. Leave the handset in the base for more than three seconds. NOTE: If the handset battery pack is completely discharged or the battery pack is removed, the digital security code will be lost. If this happens, a new security code is set automatically next time the battery pack is charged. Operational Frequency Frequency 924. 516925 ­ 926. 704425 MHz 2, 405. 155942 ­ 2, 411. 718441 MHz 7 Troubleshooting If your cordless telephone is not performing to your expectations, please try these simple steps first. If these simple steps do not solve your problem, please call our Customer Hotline at Hotline at 1-800-297-1023 (Mon-Fri 7am to 7pm, Sat/Sun/holidays--except Thanksgiving and Christmas--9am to 5pm, CST) NOTE: Do not attempt to service this unit yourself. Servicing must be performed by qualified personnel. Symptom The charge/in use LED won't illuminate when the handset is placed in the base. The audio sounds weak and/or scratchy. Suggestion · Make sure the AC adapter is plugged into the base and a wall outlet. · Make sure the handset is properly seated in the base. · Make sure that the charging contacts on the handset are clean. · Move the handset and/or base away from metal objects or appliances and try again. · Press the channel key to help eliminate background noise. · Check both ends of the telephone line cord. · · · · · · · · · Make sure the AC adapter is plugged into the base and a wall outlet. Disconnect the AC adapter for a few minutes. (see page 7. ) Make sure that the handset is not too far from the base. Check the dialing mode used by your telephone company. The handset may be too far away from the base. Move the base away from appliances or metal objects. [. . . ] Notice:The Ringer Equivalence Number (REN) for this terminal equipment is marked on the equipment itself. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. Important:Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden") ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. [. . . ]