User manual UNIDEN EXP6900

[. . . ] Color profile: Disabled Composite Default screen H:. . . Exp6900 om. vp Fri Mar 03 15:09:38 2000 Color profile: Disabled Composite Default screen Contents Introduction . 5 · Setting the Dial Mode Switch . 5 · Desk or Tabletop Installation . 6 Setting the Handset Retainer for Wall Mounting . [. . . ] Use only the AC adapter that came with the phone. Place the telephone cord into the right molded channel cord holder and plug the other end of the cord into the wall jack. (Remember, the phone must be fully charged before you can use it. ) 5. Place the base on the two posts of the wall plate and slide downward to secure. Plug the AC adapter into a standard 120V AC wall outlet that is not controlled by a wall switch. Use only the AC adapter that came with the phone. 6 Wall Installation MSetting the Handset Retainer for Wall Mounting 1. Remove the handset retainer on the base by sliding it upward. C:\Manuals\EXP6900\Exp6900 om. vp Fri Feb 18 11:07:26 2000 Color profile: Disabled Composite Default screen MMounting Directly on a Wall If you do not have a standard wall plate, you can mount the phone directly on a wall. Before mounting your cordless telephone, consider the following: Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. Make sure the wall material is capable of supporting the weight of the base and handset; otherwise, damage to the unit could result. Use #10 screws (minimum length of 1 3/8 inches) with anchoring devices suitable for the wall material where the base will be placed. Insert the screws, with their appropriate anchoring devices, 3 5/16 inches apart. Allow 3/16 of an inch between the wall and screw heads for mounting the phone. 2. Place the AC adapter cord inside the left molded channel cord holder. Plug one end of the long telephone cord into the TEL LINE jack on the base. Place the telephone cord into the right molded channel cord holder. Place the base on the screws and push down until it's firmly seated. Plug the other end of the telephone line into the telephone wall jack. (Remember, the phone must be fully charged before you can use it. ) 8. Plug the AC adapter into a standard 120V AC wall outlet that is not controlled by a wall switch. Use only the AC adapter that came with the phone. Raise the antenna on the base. 7 C:\Manuals\EXP6900\Exp6900 om. vp Fri Feb 18 11:07:27 2000 Color profile: Disabled Composite Default screen Setting Up Your Phone Raising the Antenna Before using your phone, be sure to raise its antenna to the vertical position. MSetting the Handset Earpiece Volume 1. [. . . ] The talk LED flashes, indicating the phone is changing to another channel. Using the Flash Button Use flash for accessing services such as call waiting. If you receive a call during your conversation, press the flash button on the handset. Press flash again to return to the previous call. Using the Page/Find Feature The Page/Find feature sends a signal from the base to the handset causing it to beep. This is useful for locating the handset when it is away from the base. [. . . ]