User manual UNIDEN EXP7900

[. . . ] 2 Included with Your EXP 7900 Series Phone . 6 Setting the Handset Retainer for Wall Mounting . 11 Introduction The Uniden® EXP 7900 Series 900 MHz cordless phones are designed and engineered to exacting standards for reliability, long life, and outstanding performance. The EXP 7900 Series features include AutoTalk and AutoStandby. [. . . ] Raise the antenna on the base. w Mounting Directly on a Wall If you do not have a standard wall plate, you can mount the phone directly on a wall. Before mounting your cordless telephone, consider the following: Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. Make sure the wall material is capable of supporting the weight of the base and handset; otherwise, damage to the unit could result. Use #10 screws with anchoring devices suitable for the wall material where the base will be placed. Insert the screws, with their appropriate anchoring devices, 3 5/16 inches apart. Allow 3/16 of an inch between the wall and screw heads for mounting the phone. 3/16 in. 3. Place the AC adapter cord inside the left molded channel cord holder. Plug one end of the long telephone cord into the TEL LINE jack on the base. Place the telephone cord into the right molded channel cord holder. Place the base on the screws and push down until its firmly seated. Plug the other end of the telephone line into the telephone wall jack. (Remember, the phone must be fully charged before you can use it. ) 8. Plug the AC adapter into a standard 120V AC wall outlet that is not controlled by a wall switch. 3 15/16 in. ! Use only the AC adapter that came with the phone. 9. Plug the AC adapter into the base. 9 8 2 4 6 3 5 7 7 Setting Up Your Phone Raising the Antenna Before using your phone, be sure to raise its antenna to the vertical position. The phone has two ringer tones, each with two volume levels. Press volume again until you hear the ringer tone and volume level you want. Adjusting Ringer/Volume Controls w Ringer Tone and Volume 1. While the phone is not in use, press volume . w Setting the Handset Earpiece Volume 1. The phone has two receiver volume levels, one soft and one loud. Press volume again until you hear the volume level you want. EXP 7903/7904 Charging Cradle The extra charging cradle is not a replacement for the base. Put it in a different room than the base so you can conveniently recharge the phone in the second location. Example: You want to use your cordless phone in the kitchen (an area of high interference). Connect the base in a room with low interference (without appliances, televisions or computers) then put the charging cradle in the kitchen. [. . . ] Press flash again to return to the previous call. Using the Page/Find Feature The Page/Find feature sends a signal from the base to the handset causing it to beep. This is useful for locating the handset when it is away from the base. To use this feature, press page/find on the base. (Press and hold the page/find button to get a continuous beep. ) The paging feature does not work when the phone is in use. Erasing a Stored Number 1. [. . . ]