User manual UNIDEN EXP91

[. . . ] Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: 1. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. [. . . ] Make sure the wall material is capable of supporting the weight of the Base Unit and Handset; otherwise, damage to the unit could result. Use #10 screws with anchoring devices suitable for the wall material where the Base Unit will be placed. 1. Insert the screws, with their appropriate anchor device, about 3 5/16 inches apart. Allow about 3/16 of an inch between the wall and screw heads for mounting the phone. 3 5/16" 900scrmt 2. Plug the AC Adapter into the Base Unit. AC ADAPTOR SEE OWNER'S MANUAL 93dskt 11 3. Place the AC Adapter cord inside the left channel cord holder. DIAL MODE DC IN 9V TEL LINE P· ·T AC ADAPTOR SEE OWNER'S MANUAL 93pwrin 4. Plug one end of the long telephone cord into the TEL LINE jack on the Base Unit. AC ADAPTOR SEE OWNER'S MANUAL 93teln4 5. Place the telephone cord into the right channel cord holder. AC ADAPTOR SEE OWNER'S MANUAL 93teln3 12 6. Place the Base Unit on the screws and push down until it's firmly seated. After the unit is mounted, raise the antenna. AC ADAPTOR SEE OWNER'S MANUAL 93scwmt 7. Plug the other end of the telephone line into the telephone wall jack. 93teljk 8. Plug the AC Adapter into a standard 120V AC wall outlet. AC ADAPTER Wide Blade widblde1 Note: Use only the AC Adapter supplied with the EXP91. h Route the telephone and power cords where they will not create a trip hazard, or where they could become chafed and create a fire or other electrical hazards. 13 Installing the Battery Pack The built-in Memory Backup feature allows up to 3 minutes after disconnecting the old Battery Pack to install a new one without losing any phone numbers that may be stored in the telephone's memory. To install or replace the rechargeable battery in your phone, follow these steps: Note: 1. Plug the battery's cable into the Handset. Note: The plastic connectors will fit together only one way. If you have difficulty, make sure the battery's connector is properly aligned. 3. Replace the battery cover. 14 For optimum battery performance: · · · Charge the new battery overnight before using your phone. Do not let the battery become fully discharged. Be sure to return the Handset to the base at night. Place the Handset on the base to charge. Low Battery Indicator When the Battery Pack in the Handset is low and needs to be charged, the batt low led flashes every 3 seconds. If this occurs while you are on the phone, you hear an alert tone. [. . . ] Cadmium is a chemical known to the State of California to cause cancer. The Rechargeable Nickel-Cadmium Battery contained in this equipment may explode if disposed of in a fire. Do not charge the Rechargeable Nickel-Cadmium Battery used in this equipment in any charger other than the one designed to charge this battery as specified in this Guide. Using another charger may damage the battery, or cause the battery to explode. RECHARGEABLE NICKEL-CADMIUM BATTERIES MUST BE RECYCLED OR DISPOSED OF PROPERLY Residents Of Minnesota should contact 1-800-225-PRBA for information concerning reclamation and disposal of Rechargeable Nickel-Cadmium batteries. [. . . ]