User manual UNIDEN EXP9100

[. . . ] Table of Contents About Your EXP 9100 . 5 Auto Channel Scan and Auto Channel Change . 7 Installing the Base Unit on a Desk or Tabletop . 9 Installing the Battery Pack (BT-9100) . [. . . ] If this occurs while you are on the phone, a short alert beep will also sound. Complete your call as quickly as possible. Once the battery is low, you will only be able to press the TALK button, returning the phone to Standby. Return the Handset to the Base Unit for charging. Allow 5 to 7 hours without interruption for the Battery Pack to fully recharge. Or, replace the Handset's Battery Pack with a charged Battery Pack. 2. Cleaning the Battery Contacts CONTACTS CONTACTS To maintain a good charge, it is important to clean all charge contacts on the Handset and Base Unit about once a month. Use a pencil eraser or other contact cleaner. Do not use any liquids or solvents 13 Using Your EXP 9100 NOTE: Refer to the foldout located in the back of this Operating Guide to help familiarize you with the features of your cordless phone. Preparing the Base Unit and Handset 1. On the Base Unit, select either Pulse Dialing or Tone Dialing, depending on your local service. Set the Base Unit RINGER/VOLUME switch to either "LO" or "HI" enabling the Base Unit to ring when a call or page is received. Set the Handset RING/BATT SAVE switch so the Handset will ring when receiving a call. NOTE: The TALK LED and keypad lights flash when the Handset receives a call regardless of the RING/BATT SAVE switch position. 4. TONE button on the Handset to select either of two ringer sounds. (Note: This sets the ringer tone only when the phone is not in use. ) Press the VOL/R. VOL button on the Handset to select either high, medium, or low ringer volume. (Note: This sets the ringer volume only when the phone is not in use. ) 5. During a Call Handset Earpiece Volume: Press VOL/R. VOL on the Handset to select a loud or soft volume level in the Handset earpiece. Mute Mode: Press MUTE to turn off the Handset's microphone. The MUTE LED lights to show Mute Mode is active. Use this feature to consult another person in the room without the caller hearing you. Out of Range Indicator: When the Handset is reaching the end of the EXP 9100's range limit, a beep sounds in the earphone every four seconds. If the Handset goes farther out of range, the warning beeps every 1. 5 seconds. You must go back into range within 20 seconds or the call will be dropped. [. . . ] : Crystal controlled transmission : MSK : -10° to 50° C : 120V AC, 60 Hz 5 : 6 3 in. H 4 8 170mm W X 22mm D X 80mm H : Approx. (345g) with battery : BT-9100 Capacity Talk Mode Standby Mode 600 mAH, 6V 3 hours (typical) 1 week Specifications shown are typical and subject to change without notice. 22 ® EXP 9100 Cordless Telephone Operating Guide PRECAUTIONS Before you read anything else, please observe the following: WARNING! Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture. NICKEL-CADMIUM BATTERY WARNING This equipment contains a Nickel-Cadmium Battery. [. . . ]