User manual UNIDEN EXS9005

[. . . ] Precautions Before you read anything else, please observe the following: Warning! Uniden America Corporation DOES NOT represent this unit to be waterproof. To reduce the risk of fire, electrical shock, or damage to the unit, DO NOT expose this unit to rain or moisture. Rechargeable Nickel-Cadmium Battery Warning s This equipment contains a Rechargeable Nickel-Cadmium Battery. s Cadmium is a chemical known to the State of California to cause cancer. s The Rechargeable Nickel-Cadmium Battery contained in this equipment may explode if disposed of in a fire. s Do not short-circuit the battery. s Do not charge the Rechargeable Nickel-Cadmium Battery used in this equipment in any charger other than the one designed to charge this battery as specified in this Guide. [. . . ] Place the AC Adapter cord around the strain relief notch. 3. Plug one end of the long telephone cord into the TEL LINE jack on the Base Unit. 4. Plug the other end of the cord into the telephone jack on the wall. 10 EXS9005 5. Plug the AC Adapter into a standard 120 VAC wall outlet. Do not use an outlet controlled by a wall switch. Use only the Uniden AC Adapter supplied with this phone. Place the Base Unit on a desk or tabletop. In desk or table top installation, the Handset is designed to stand only vertically in the Base Unit. DO NOT lay the Handset down on the Base Unit. EXS9005 11 Installation Wall Installation Standard Wall Plate Mounting These phones are designed to be mounted on a standard AT&T or GTE wall plate. To attach the wall mount to the Base Unit: 1. Slide the wall mount into the notches at the top of the Base Unit. 2. Rotate the wall mount stand down and snap into place. 3. Plug the AC Adapter into the Base Unit. 12 EXS9005 4. Wrap the AC Adapter cord around the strain relief notch. Then put the AC Adapter cord inside the molded channel. 5. Plug one end of the short telephone cord into the TEL LINE jack on the Base Unit. Place the telephone cord inside the molded channel on the bottom of the Base Unit. Then plug the other end of the telephone cord into the modular jack on the wall. 6. Place the Base Unit on the posts of the wall plate and push down until it's firmly seated. EXS9005 13 Installation 7. Plug the AC Adapter into a standard 120 VAC wall outlet. T Do not use an outlet controlled by a wall switch. Direct Wall Mounting If you do not have a standard wall plate, you can mount your phone directly on a wall. Before mounting your phone, consider the following: · Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. · Make sure the wall material is capable of supporting the weight of the Base Unit and Handset. · Use #10 screws with anchoring devices suitable for the wall material where the Base Unit will be placed. [. . . ] cord. · Make sure that the Base Unit antenna is vertical. · Move the Handset and/or Base Unit to different · Check both ends of the Base Unit telephone line · Make sure the AC Adapter is plugged into the Base Unit and wall outlet. and then reconnect it. · Disconnect the AC Adapter for a few minutes, · Check TONE/PULSE switch position. Handset doesn't ring or receive · Nickel-Cadmium battery pack may be weak. a page. · · Handset does not fully charge. · · Charge the battery on the Base Unit for 15 to 20 hours. [. . . ]