User manual UNIDEN FRS1400-2

[. . . ] If the interference goes away, your radio is causing it. Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using the radio. Audio Accessories: Do not operate the radio with audio accessories at high volume levels. [. . . ] 5 Belt Clip Installation Because you will most likely use your radio when you are out and about, the unit comes equipped with a belt clip to securely fasten the unit to your belt, pocket or purse. Insert the belt clip screw into the slot on the belt clip. 2. Align the screw with the hole on the back of the radio and turn it clockwise, using a Phillips screwdriver to secure the belt clip. The belt clip can be attached so that it rests vertically or horizontally. Turn the screw counterclockwise to loosen the belt clip and change its position. Attaching the Hand Strap The hand strap for the FRS radio can be attached to the belt clip for added transporting convenience. Simply thread the long end of the hand strap through the hole on the belt clip, then loop the long end through the short end and pull tight. 7 Using Your Radio In order to get the most out of your new radio, read this reference guide completely before attempting to operate the unit. Turning the Radio On 1. Turn the on/off volume control clockwise to turn the unit on. 2. Turn the control counterclockwise to turn the unit off. 8 Adjusting the Volume 1. Press the MONI button to hear background noise. 2. Turn the on/off volume control clockwise to increase the volume, counterclockwise to decrease the volume. Adjusting the Sound Your radio emits a beep each time one of the buttons is pressed. To turn this sound off, press PTT and MONI at the same time. Press them again to turn the sound back on. 9 Choosing a Channel and Privacy Code Your radio has 14 channels and 38 privacy codes (FRS 1600 series only) you can use to talk to others. In order to speak to someone, each of you must be set to the same channel and privacy code. To choose a channel for the FRS1600 series: 1. Press the mode/scan button to move the w indicator to the channel mode. (The mode/scan button allows you to switch between channel and code mode on the FRS1600 series only. ) The FRS1600 series is equipped with a mode/scan button. The FRS1400 series has a scan button. 10 2. Press the up or down button repeatedly to select one of the 14 channels. (The number on the LCD changes to indicate a new channel has been selected. ) To choose a channel on the FRS1400 series follow step 2 above. 11 Your radio also allows you to scan for active channels. Press and hold the mode/scan button for one second to begin scanning channels. The LCD will indicate you are in scan mode. If a signal is present, the radio will stop on the active channel for five seconds. [. . . ] · Confirm radios have the same channel and privacy code setting. · Make sure PTT is not inadvertently being pressed. · Reposition or replace batteries. · Obstructions, operating indoors or in vehicles may interfere with communication. [. . . ]