User manual UNIDEN GMR1058-2CK REFERENCE GUIDE

[. . . ] GMR1058-2CK(4CK) · Power Boost Button for Maximum Range · 15 GMRS / 7 FRS Channels · Up to 10 Mile Range* · 5 Selectable Call Tone Alerts · Backlit LCD Display · Roger Beep · Key Beep on/off · 38 CTCSS Code · Optional Headset Accessory · Headset Jack · · · · · · Battery Level Meter Channel Monitor Channel Scan Keypad Lock Belt Clip NiMH Battery Pack and Charger Congratulations on your purchase of the Uniden GMR1058-2CK(4CK) (General Mobile Radio Service) radios. These products are lightweight, palm-sized radios. Use them at sporting events to stay in contact with family and friends, hiking, skiing, outdoors, or in a neighborhood watch for vital communication. These compact, state-of-theart devices are equipped with many features. compartment. [. . . ] GMRS channels 1-7, 15-22 have an expectancy range of up to 10 miles by pressing the Power boost button. You can know which GMRS or FRS channel is active by the icon. The icon indicates GMRS channel, and the icon indicates FRS channel. Choosing a CTCSS Code Each of the channels 1-22 may have any one of the codes, OFF or 1-38 selected. Code oF (OFF) indicates no CTCSS code selected and your radio can receive a signal regardless of the code settings of the transmitting radio. 1 14 15 16 17 18 8 19 21 22 23 2 3 4 5 6 7 9 10 11 12 13 26 20 24 25 Your GMR1058-2CK(4CK) radio is equipped with a user selectable Voice Operated Transmitter (VOX) that can be used for automatic voice transmissions. The VOX feature is designed to be used with a headset with a microphone. Transmission is initiated by speaking into the remote microphone instead of pushing the PTT button. To select the VOX level: 1) Enter the Menu. Advance through the Menu until the vox icon appears on the display. The current level (OFF, 1-3) will be indicated. Level oF (OFF) disables VOX, while levels (1-3) set the sensitivity of the VOX circuit. 2) Press either the L or M key to the desired VOX sensitivity level. Use level 1 for increased sensitivity to voice in normally quiet environments, and use a higher level to reduce undesired activation in very noisy environments. Transmitting a Call Tone Your GMR1058-2CK(4CK) radio is equipped with 5 selectable call tones that will be transmitted when the call key is pressed. 1) Press and hold the sel/ key to turn the unit OFF. 2) Press and hold the sel/ key again to turn the unit ON. Channel Scan Feature Your GMR1058-2CK(4CK) radio has a channel Scan feature that allows you to easily Scan all 22 channels. When an active channel is detected, the unit will pause on that channel until the channel is clear. Then after a 2 second delay, the unit will continue scanning. Pressing the PTT or Power boost button while the Scan is paused on a channel will allow you to transmit on that channel. To turn ON channel scanning: Press scn key until the scan. . . The channel number on the display will change as the radio rapidly cycles through the channels. To turn OFF channel scanning: Press the sel/ key, call key, scan key, PTT button or Power boost button. 27 INSTALL THE BATTERIES 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Antenna PTT (Push-To-Talk) Button Power boost Button Monitor Key Call Key Scan Key Speaker Channel Key Headset Jack Up Key On/off/select Key Down Key Microphone Battery Level Meter 15 16 17 18 19 20 21 22 23 24 25 26 27 Receive Indicator Power Boost Indicator Call Indicator Scan Indicator Channel Indicator CTCSS Indicator Transmit Indicator Volume Setting Indicator VOX Indicator Keypad Lock Indicator GMRS/FRS Indicator Charging Contacts Charging LED Your GMR1058-2CK(4CK) radio uses the NiMH battery pack or 4 AAA alkaline batteries (not included). [. . . ] Please adhere to the following: Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could impair call quality, damage the radio, or result in violation of FCC regulations. Do not use the radio with a damaged antenna. If a damaged antenna comes into contact with the skin, a minor burn may result. [. . . ]