User manual UNIDEN LRD2200SWS OPERATING GUIDE

[. . . ] Introduction Welcome to the world of sophisticated, early warning laser/radar detection. You have purchased one of the most advanced laser/radar detectors available. The LRD 2200SWS is a complete integrated laser/radar detector. It responds to the X-, K-, and Ka-SuperWideband radar guns in use today and also provides 360° detection of the latest speed monitoring system -- the laser gun. [. . . ] Mounting the LRD 2200SWS behind tinted or mirrored glass may reduce the effectiveness of laser detection by reducing the amount of laser light received by the Detector. Helpful Tips The antenna and the forward looking sensor are located behind the rear panel of the unit, (and the rear- and side-looking sensors are located on top of the unit), directly behind the mode selection keys. The antenna and sensors should not be obstructed by metal or metallic surfaces and should be pointed at the horizon for accurate long-range detection. · Do not mount the unit behind the windshield wiper blades, radio antenna, tinted glass area, or mirrored glass. Be sure the unit is free from obstruction by seat backs, rear view mirror, sun visors, or the ceiling of the automobile. · Do not mount the unit in front of the heater or defroster vents. · Do not leave the unit in direct sunlight or in the glove compartment of a closed car for long periods of time, as extreme changes in temperature may cause internal damage. Also, removing the unit from the windshield makes you less susceptible to break-in and theft. 8 Adjusting the Windshield Mounting Clip 1. The metal portion of the bracket locks into the plastic portion at three different positions. These positions can be used for vehicles with different vertical angles of their windshields. The back position can be used for vehicles with windshields that are slanted back. For optimum laser detection, bend the angled portion of the windshield mounting bracket so that the LRD 2200SWS is parallel to the road surface. Be sure the LRD 2200SWS is mounted so it is free of obstructions from seat backs, rear view mirror, sun visors, or the ceiling of the automobile. There must be a clear 360° line of sight to the outside of the vehicle. 2. To mount the LRD 2200SWS: 1. Insert the windshield clip into the LRD 2200SWS. Place the bracket and the LRD 2200SWS in the proper location on the windshield of your vehicle, and press the suction cups firmly against the windshield. 9 Connecting the Power Direct Connection The LRD 2200SWS is designed to operate on most 12V DC negative ground vehicle electrical systems. The straight power cord provided with the unit has bare wires at one end, and a small connector at the other end. Connect the positive wire to a 12V DC source in your vehicle's fuse box. Please read this section of the Operating Guide carefully to familiarize yourself with the basic operation of this unit. Power On Turn the Volume control to switch on the power. When you power up the LRD 2200SWS, it performs a self-test of all its circuits. This test takes about 5 seconds, during which you will hear the different alarm tones and see all the LEDs. First, you will hear the X-band alarm for 2 seconds while the X-band indicator, City, and Mute LEDs light. The test also checks the signal meter LEDs. It is best to adjust the audible alarm during the self-test. [. . . ] Federal and Local Regulations The FCC passed the Communications Act in 1934 to give all citizens the right to receive any type of radio transmission. The same radio frequencies used by police radar are also used by other devices, such as automatic door openers, burglar alarms, and some amateur radio equipment. Since the LRD 2200SWS is just a radio receiver tuned to a specific portion of the public radio spectrum, it is protected under this act. Some local, state, and federal regulations may prohibit the use of this detection device. [. . . ]