User manual UNIDEN LRD6275SWS REFERENCE GUIDE

[. . . ] NTROLS & FUNCTION INCLUDING L CONTENTS OF YOUR REFERENCE GUIDE CONTENTS Feature Highlights . 9 Adjusting the Windshield Mounting Clip . 16 LED Signal Strength Meter in City Mode . 20 NOTE: Foldout the back cover of this reference guide to refer to the Controls & Functions page. Introduction . [. . . ] Ka-SuperWideband Signal Indicator A red LED lights and blinks to indicate the presence of a Ka-SuperWideband radar signal. The blink rate increases as the radar source gets closer. Power-On Indicator A green LED under P lights to indicate power is being supplied to the unit and the unit is turned on. LED Signal Strength Meter Three LEDs give an accurate visual indication of the strength of radar or laser signals. City Mode Indicator A green LED under C lights to indicate that you selected City Mode. Auto Mute Indicator A red LED under M lights to indicate that you selected the Auto Mute feature. LED Signal Strength Meter Three LEDs give an accurate visual indication of the strength of radar or laser signals. Every time you turn on the LRD 6250SWS/ LRD 6275SWS, a self test is performed for all LEDs and Alert tones. You will hear, in-order, four distinct tones for the X-, K-, and Ka-SuperWideband radar bands, as well as for laser, laser L2 and SWS. D3) D4) D5) D6) D7) Laser Signal Indicator For laser signals, a red LED under L lights and blinks to indicate the presence of a laser signal. For the UltraLyte laser gun, an amber LED under L lights and blinks to indicate the presence of a UltraLyte laser signal. D9) SWS Signal Indicator When an early warning hazard or informational signal is detected, the green SWS LED begins to blink. These positions can be used for vehicles with different vertical angles of their windshields. The back position can be used for vehicles with windshields that are slanted back For optimum laser detection, bend the angled portion of the windshield mounting bracket so that the LRD 6250SWS/ LRD 6275SWS is parallel to the road surface. Be sure the LRD 6250SWS/LRD 6275SWS is mounted so it is free of obstructions from seat backs, rear view mirror, sun visors, or the ceiling of the automobile. There must be a clear 360° line of sight to the outside of the vehicle. Press the button on top of the radar and insert the windshield clip into the LRD 6250SWS/ LRD 6275SWS. The metal portion of the bracket locks in to the plastic portion. Place the bracket and the LRD 6250SWS/LRD 6275SWS in the proper location on the windshield of your vehicle, and press the suction cups firmly against the windshield. 2) To mount the LRD 6250SWS/LRD 6275SWS: 1) 2) 10 CONNECTING THE POWER The LRD 6250SWS/LRD 6275SWS is designed to operate on most 12 VDC negative ground vehicle electrical systems. The power cord provided with the unit has a cigarette lighter socket plug at one end and a small connector at the other. 1) Insert the small connector into the jack on the side of the unit. INSTALLATION 2) Insert the other end into the cigarette lighter socket of your vehicle. When installing the power cord, make sure that: · The socket is clean to allow proper contact. · The power cord does not block the antenna area on the back of the unit. Your unit also comes with ten power cord mounting clips. You can use these clips to attach the power cord to the window frame or other parts of the vehicle, keeping it neat and out of the way. Use the double-sided foam tape squares to attach each clip. Slip the power cord into the clip to hold it securely in place. 11 REPLACING THE FUSE The cigarette lighter plug contains a 1-ampere fuse to protect it from power surges. [. . . ] When this alert sounds, you should tune to local radio traffic reports or prepare to slow down or stop your vehicle because you could be approaching an accident, bad road conditions caused by weather, or road crews or construction. 17 CARE & MAINTENANCE OF YOUR NEW LASER/RADAR DETECTOR CARE AND MAINTENANCE The LRD 6250SWS/LRD 6275SWS is designed to give you years of trouble-free service. There are no user-serviceable parts inside, and, except for the fuse, no maintenance is required. To keep your detector in new condition, follow these important suggestions: · Never leave the LRD 6250SWS/LRD 6275SWS on the windshield when you park your vehicle. The temperature in the vehicle in summer can reach levels above what is considered to be safe for this unit. [. . . ]