Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual UNIDEN PRO510XL. We hope that this UNIDEN PRO510XL user guide will be useful to you.
Lastmanuals help download the user guide UNIDEN PRO510XL.
Detailed instructions for use are in the User's Guide.
[. . . ] An operator of an CB radio station is still required to comply with the Communications Act and with the rules of CB Radio Service.
INCLUDED IN YOUR PACKAGE
If any of these item are missing or damaged, immediately contact your place of purchase or Uniden Customer Service at: (800) 554-3988, 8:30 a. m. to 5:00 p. m. , Central Time, Monday through Friday.
CB Radio
Microphone
Mounting Bracket
Mounting Hardware
Other Printed Material
Antenna must be purchased separately.
CONTROLS AN
1. ANL Switch - You can select the Automatic Noise Limiter to help reduce harsh background noise caused by a variety of interference sources. TX LED - An LED lights to indicate when the radio is transmitting. [. . . ] The most efficient and practical installation is a full quarter wave whip antenna mounted on the rear deck or fender top, midway between the rear window and bumper. A short "loaded" whip antenna maybe more convenient to install on your automobile, although the efficiency is less than a full quarter wave whip antenna. For marine installation, consult your dealer for information regarding an adequate grounding system and prevention of electrolysis between fittings on the hull and water.
Ground Information
Most newer U. S. and foreign made cars and small trucks use a negative ground system, while some older cars and some newer larger trucks may use a positive ground system. A negative ground system is generally identified by the "-" battery terminal being connected to the vehicle motor block, but if you cannot determine the polarity of your vehicle, consult your vehicle dealer for information. NOTE: This radio may be installed and used in any 12-volt DC negative or positive ground system.
Negative Ground System
If you are operating on a negative ground system, connect the red DC power cord from the radio to the positive "+" battery terminal or other convenient point and connect the black power lead to the chassis or vehicle frame, or the " -" terminal of the battery.
Positive Ground System
If you are operating on a positive ground system, connect the black DC power cord from the radio to the "-" battery terminal or other convenient point and connect the red power lead to the chassis or vehicle frame, or the positive "+" terminal of the battery.
OPERATION
Operating Procedure to Receive 1. Be sure that the power source, antenna and microphone are properly connected. Turn the unit on by rotating the volume control clockwise. Set the channel selector switch to the desired channel. Set the volume control to a comfortable listening level. Listen to the background noise from the speaker. Turn the squelch control clockwise until the noise disappears (no signal should be present). The receiver will remain quiet until a signal is actually received. Do not advance the control too far, or some weaker signals will not be heard. Be sure the operator has read and understands part 95, FCC rules and regulations prior to operating the transmitter. Select the desired channel for transmission. If the channel is clear, depress the push-to-talk switch on the side of the microphone and speak in a normal voice. CAUTION: The transceiver Voltage Standing Wave Ratio (VSWR) measurement must be performed prior to the use of the transmitter. A VSWR in excess of 2:1 may damage the transmitter. Please check your SWR reading frequently by using an SWR meter.
Preventative Maintenance
At six to twelve month intervals, the following system checks should be made: 1. Check the Voltage Standing Wave Ratio (VSWR). Inspect all screws and other mounting hardware.
TROUBLESHOOTING
If your PRO 510XL is not performing to your expectations, please try these simple steps. [. . . ] Occupation J Homemaker J Teacher/Educator J Professional Driver J Executive/Administrator J Civil Servant J Sales/Marketing J Clerical J Farmer/Agriculture J Military J Technical/Professional J Business/Professional J Craftsman J Machine Operator/Laborer J Retired J Student 22. Please check your approximate family income. J Under $10, 000 J $10, 000 - 19, 999 J $20, 000 - 29, 999 J $30, 000 - 39, 999 J $40, 000 - 49, 999 J $50, 000 - 59, 999 J $60, 000 & Over
CUT
CUT
PLACE FIRST CLASS STAMP HERE
PO BOX 8283 Denver, CO 80201-8283
ATTN: PC MARKET RESEARCH DEPARTMENT
Please do not send any products or service related correspondence to this address.
Please fold here
23. J American Express, Diners Club, Carte Blanche J Road & Track J Bank Card (Master Card, Visa, etc. ) J Car & Driver J Gasoline Card. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE UNIDEN PRO510XL
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual UNIDEN PRO510XL will begin.