User manual UNIDEN TRU241

[. . . ] OWNER'S MANUAL TRU241 CONTENTS Introduction 1 Features . 1 Included with Your TRU 241 Phone Controls and Functions 3 4 Installation 5 · Charging the Battery Pack. 6 · Setting the Dial Mode Switch . 6 · Mounting the Base Unit on the Wall . [. . . ] On the base unit, pull the handset retainer out of the slot. Slide it back into the slot so that the lip of the retainer is up and the oval is down. The retainer holds the handset in place. AC adapter AC outlet Wall plate INSTALLATION INSTALLATION [7] Direct Wall Plate Mounting If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following: · Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. · Try to mount your phone within 10-15 feet of a working phone jack to avoid excessive cord lengths. · Make sure the wall material is capable of supporting the weight of the base and handset. · Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material where the base unit will be placed. Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 3/16 of an inch between the wall and screwheads for mounting the phone. Refer to steps 1 through 9 as in the "Mounting the Base Unit on a Wall" section. (See page 7. ) TOP 3/16 in. 3-15/16 in. [8] INSTALLATION SETTING UP YOUR PHONE SETTING UP YOUR PHONE Raising the Antenna Before using your phone, be sure to raise its antenna to the vertical position. Connect the base unit If you want to install the base unit on the wall, see page 7. Connect the telephone line cord to the TEL LINE jack and to a telephone outlet. Connect the AC adapter to the DC IN 9V jack and to a standard 120 V AC wall outlet. Set the base unit on a desk or tabletop and place the handset on the base unit. Then raise the antenna to a vertical position. Route the cord To AC outlet To DC IN 9V AC adapter(supplied) To telephone outlet Telephone line cord (supplied) Place the power cord so it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard. To TEL LINE Adjusting Ringer/Volume Controls w Ringer Tone and Volume 1. While the phone is not in use, press volume . The phone has two ringer tones, each with two volume levels. Press volume again until you hear the ringer tone and volume level you want. w Setting the Handset Earpiece Volume 1. The phone has four receiver volume levels, Low, Medium, High, and Maximum. Press volume again until you hear the volume level you want. When you hang up, the phone keeps the last volume setting selected. [. . . ] Make sure the rechargeable battery pack is properly connected in the handset. Make sure that the charging contacts on the handset and on the base are clean. Make sure that the base antenna is in the vertical position. Interference by other electronic equipment such as TVs. [. . . ]