User manual UNIDEN TXC400

[. . . ] If any of these items are missing or damaged, contact the Uniden Parts Department. · Cordless Handset · Charger · Battery Pack (BT-446) (Capacity: 800 mAH, 3. 6V) · AC Adapter (AD-446) (INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA) · Beltclip · This Owner's Manual · Other Printed Material Uniden Parts Department at (800) 554-3988 Hours: M-F 7:00 a. m. We can also be reached on the web at www. uniden. com. ­2­ Install the Battery Pack Charge the battery pack for at least 15-20 hours before completing the installation or using the handset. battery 1 Press down on thethe cover cover until release and slide down it comes off. 2 Connect the battery pack connector observing the correct polarity (black and red wires) to the jack inside the battery compartment. Do not exert any force on this connection. [. . . ] · Use only the supplied AD-446 AC adapter. · Place the charger close to the AC outlet so that you can unplug the AC adapter easily. · "HS2" appears on the display while the handset is charging. Polarity of the plug ­4­ Register the Handset You need to register the TXC400 before use. To register the additional handset, do the following steps in compliance with your original unit. For TRU446/TRU4465/TRU448/TRU4485 unit Place the TXC400 handset on the original unit's base until you hear a confirmation tone. If the original base is mounted, you will need to hold the handset to the base until the status LED on the unit's base is illuminated. · If the original base is a TRU448, to register the TXC400, place the TXC400 on the TRU448 base with the keypad facing down. · If you did not hear the confirmation tone, register the TXC400 again. · In some cases you may need to attempt registration a few times. For TRUC46 (Card Phone) unit 1 2 3 Unplug the AC adapter of the TRUC46. Press and hold PAGE on the TRUC46 base, while you plug in the AC Adapter, until the status LED on the base flashes. Press talk/flash on the TXC400's handset. "Handset Registering" appears. When the operation is finished, you will hear a confirmation tone and "Registration Complete" will appear. The status LED is no longer illuminated. · If the registration fails, "Registration Failed" appears. · You must complete the registration operation within 30 seconds, or the phone returns to the standby mode. If you changed the digital security code of the original unit: You need to perform the following steps: code 1 De-register the digital securityDigital of the TXC400. (For instructions, see "Change the Security Code" in the owner's manual supplied with the original unit. 2 Register the TXC400 to the original base by following the steps above. ­5­ Call Transfer Feature You can transfer an outside call to the original unit. For more instructions, see the owner's manual supplied with the original unit. To transfer a call to the original unit To receive a transferred call from the original unit To cancel the transfer Press xfer/del during a call. When the original unit receives the transfered call, the TXC400 handset returns to the standby mode. Press talk/flash to answer the transferred call. [. . . ] Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). [. . . ]