User manual UNIDEN TXC580

[. . . ] We can also be reached on the web at www. uniden. com. ­2­ Install the Battery Pack Charge the battery pack for at least 15-20 hours before completing the installation or using the handset. 1 Press down on the battery cover until release and slide the cover down it comes off. 2 Connect the battery pack connector observing the correct polarity (black and red wires) to the jack inside the battery compartment. Do not exert any force on this connection. It could cause damage to the battery or to the handset. The plastic connectors will fit in only one way. [. . . ] · Place the charger close to the AC outlet so that you can unplug the AC adapter easily. · "HS2" appears on the display while the handset is charging. 3 Polarity of the plug ­4­ Register the Handset You need to register the TXC580 before use. To register the additional handset, place the TXC580 handset on the original unit's base for at least 5 seconds. The status LED on the original base will flash indicating that registration is occurring. After 5 seconds, the TXC580 handset will be registered. · In some cases you may need to attempt registration a few times. · You cannot register the handset when the original phone is in use. Using the TXC580 with the Integrated Answering Device If the original unit has a built-in answering system, you can check your new messages, skip, repeat, or delete your messages with the TXC580 handset. For more instructions, see the owner's manual supplied with the original unit. To To To To To To playback a message skip a message repeat the current message repeat the previous message delete a message stop operation Press Press Press Press Press Press -. end. · If you press end before the answering system answers, the phone will return to the standby mode. · When the answering system does not answer within 7 seconds, you will hear a beep and the phone will return to the standby mode. · When you receive a call, the remote operation is canceled. ­5­ Call Transfer Feature You can transfer an outside call to the original unit. For more instructions, see the owner's manual supplied with the original unit. To transfer a call to the original unit To receive a transferred call from the original unit To cancel the transfer Press xfer/del during a call. When the original unit receives the transferred call, the TXC580 handset returns to the standby mode. Press talk/flash or spkr to answer the transferred call. Press talk/flash or spkr. · If you transfer a call and it is not picked up after 5 minutes, you hear a beep, and the call will be disconnected. · Only one handset at a time can talk with an outside caller. I. C. Notice TERMINAL EQUIPMENT NOTICE: This equipment meets the applicable Industry Canada Terminal Equipment Technical Specifications. This is confirmed by the registration number. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. [. . . ] Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America. PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after following the instructions in the owner's manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). [. . . ]