User manual UNITED OFFICE ULG 300 A1 A3 LAMINATOR

[. . . ] Read the operating instructions carefully before using the device for the first time and preserve this booklet for later reference. Pass this manual on to whoever might acquire the device at a future date. This laminator is intended exclusively for use in private households and for the hot and cold lamination of documents printed on paper or cardboard. additionally , the documents can be trimmed. [. . . ] Make certain that you use only one pouch for laminating. For information about the lamination process, please read section 10. Lay the document to be laminated into a laminating pouch of the appropriate size. If you have previously performed hot lamination: After hot laminating, allow the laminator to cool down completely before beginning with cold lamination. Remember, the rollers inside the laminator will still be hot. Lay the laminating pouch onto the pouch guide q. Lay the right or left edge of the laminating pouch against the pouch format lock r (closed side leading). Slide the pouch format lock r together until the selected format size is reached. This prevents the laminating pouch from being pulled in at an angle. Should the laminating pouch be pulled in at an angle, use the "Anti-Blocking Funktion" as described in chapter 11. Pull out the document supports s so that the documents can be pulled in straight into the slot for manual foil feed t. Insert the plug of the laminator into a mains power socket. Take note: For cold lamination, ALWAYS place the foil thickness switch o at 125 microns. The red ON/OFF indicator lamp u and the green indicator lamp "Ready" y now glow. Now slide the laminating pouch slowly into the When you have slid the laminating pouch several Centimetres into the slot t, it will start to be pulled in automatically. Release the laminating pouch as soon as you notice it being pulled in automatically. Ensure there is at least 45 cm of open space in front of the laminator. If you do not, the laminating pouch will not be completely ejected from the laminator after lamination. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch, as shown in Fig. Make certain that you use only one pouch for laminating. For information about the lamination process, please read section 10. The finished laminated pocket is now ejected from the foil slot a of the laminator. [. . . ] observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. Release the sheet as soon as you notice it being pulled in automatically. The contaminants on the rollers inside the laminator now firmly attach themselves to the sheet of paper. [. . . ]