User manual UNITED OFFICE ULG 350 A1

[. . . ] 6 Laminator ULG 350 A1 Laminator Operating instructions KOMPERNASS GMBH BURGSTRASSE 21 · D-44867 BOCHUM www. kompernass. com ID-Nr. : ULG350A1-04/10-V1 ULG 350 A1 1 2 3 w q 4 5 6 9 0 8 7 Content 1. Importer Page 2 2 2 2 3 4 4 5 6 6 7 7 8 8 8 9 9 Read these operating instructions carefully before using the appliance for the first time and preserve this maual for later reference. Pass this manual on to whoever might acquire the appliance at a future date. -1- Laminator 1. Intended use This laminator is intended exclusively for use in private households and for the hot and cold lamination of documents printed on paper or cardboard. [. . . ] Suitable laminating pouches · For hot lamination you can use pouches with a width of up to 230 mm and a maximum thickness of 125 micron. · Please note that each laminating pouch may only be used once. For hot lamination, use only laminating pouches that are expressly designated for hot lamination. For cold lamination, use only laminating pouches that are expressly designated for cold lamination. Take note that the laminating pouches included with the laminator are intended exclusively for hot lamination. 7. Operating levels Position of selector switch i Position of pouch thickness switch o Laminating foil thickness HOT HOT Cold 80 125 125 > 60 - 80 85 - 125 to 200 Tip: For high-gloss photos, you should select the switch position "125" as well as the appropriate pouch thickness. -4- 8. Preparing for hot lamination Insert the pouch guide q into the holes provided on the rear of the laminator. If not already done, fold the trimming attachment d down. Pull the document support s out, so that the document can be pulled in straight into the slot for manual pouch input t. Insert the laminator plug into a mains power socket. Ensure the appliance has a stable positioning. Switch the appliance on by placing the selector switch for hot and cold lamination i at "HOT". The red ON / OFF indicator lamp y now glows. Activate the pouch thickness switch o only when the appliance is switched on. Otherwise, the appliance could be irreparably damaged. Lay the document to be laminated into a laminating pouch of the appropriate size. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch, as shown in Fig. Make certain that you use only one pouch for laminating. 1 For information about the lamination process, please read section 10. · Place the pouch thickness switch o at the desired pouch thickness (80 or 125 micron). The laminator now heats itself up to the operating temperature. The laminator has reached its operating temperature as soon as the green LED indicator light "Ready" u glows. Attainment of the operating temperature is indicated by the lighting up of the green LED indicator lamp "Ready" u. For a more uniform laminating result we recommend, especially for thinner foils (below 125 Micron) and after adjustment to a different foil thickness, to first wait an additional 2-3 minutes before beginning with lamination. -5- Fig. [. . . ] Slide the cutting head e to the end stop (the cutting head e can be slid to both ends of the cutting rail w). Flap the cutting rail w upwards with the rounded grip and position the document on the pouch guide q. Restrain the document by sliding the pouch format locks r together until they touch both sides of the document. Use the markings on the measurement table to align the document precisely. [. . . ]